LG 14CC3AB Owner's Manual

Page of 12
5
-
POWER BUTTON (or ON/OFF)
Refer to "Turning on/off the TV".
-
REMOTE CONTROL SENSOR
-
STAND BY INDICATOR
Illuminates red when the TV is in standby mode. Refer to "Turning on/off the TV".
-     TV/VIDEO BUTTON
To select TV, VIDEO or COMPONENT mode.
-
MENU BUTTON
To display on-screen.
-
CHANNEL UP/DOWN (
D
/
E
) BUTTONS
• To select the desired channel.
• To select the desired menu item when menu
is displayed on the screen.
VOLUME UP/DOWN (
F
/
G
) BUTTONS
• To increase or decrease volume level.
• To enter or adjust the selected menu when
menu is displayed on the screen.
ENTER (
A
) BUTTON
• To exit from the displayed menu. 
• To memorize the adjusted menu.
• To recall the current TV mode (by remote control only).
You can connect additional equipment, such as VCRs, camcorders etc. to your set.
Here shown may be somewhat different from your set.
These are an example drawing of typical jack layout.
IN JACKS (some models) :Connect external equipment outputs (VCR, LASER DISC,
CAMCORDER) to these  inputs. Press the TV/VIDEO button to select 
VIDEO
or 
VIDEO
1
.
Note:This TV is programmed to remember which mode it was last set to, even if you turn the TV off. 
Connection of external equipment (some models)
VIDEO
AUDIO
IN
Description of controls (front pane)
Antenna Connections
Connecting an Outdoor Antenna
For the best reception, we recommend you use an outdoor antenna.
Severely weathered antennas and antenna cables can reduce the signal quality. Before connecting it,
necessarily inspect them. Any service center can explain the various outdoor antennas available to you.
Connecting a CATV Cable
If you subscribe to a CATV system, change the antenna connection as described below. 
1. Remove the 300 to 75 ohm adapter or the cable from the set if attached.
2. Connect the CATV cable (75 ohm coaxial cable) to the antenna jack.