Eaton TPC115-10A2/MTD User Manual

© 2008 Eaton Corporation. All Rights Reserved. All specifications are subject to change without notice.

•

19” x 1.72” (1U) x 8.0”

•

Approximate shipping weight: 14 lbs.

•

2 unswitched on front and 8 switched    
on rear panel. Unswitched outlets are    
tied to the SW-II outlet section

•

Power cable with plug is attached to unit 
through the rear panel cable grip

•

Main breaker power “on” and power to    
the unswitched outlets

•

Power “on” to the SW-I outlets

•

Power “on” to the SW-II outlets

•

L-N, L-G, N-G

•

Common Mode Line to Ground

•

Differential Mode Line to Line

•

Electromagnetic breaker 
provides manual on/off switching and    
trips in an overload condition

•

Local: Power “on or off” to the switched   
outlets

•

Off: When breaker is “on” but this switch 
is in the “off” mode, you will have power 
to the unswitched outlets only

•

Remote: Power “on or off” to the  

 

switched outlets via a remote device

•

Latching remote, on “LT” systems, has   
the selection switch wired for  

 

Remote/Off/Remote - There is no local   
control

•

Activated “locally” or “remotely”, SW-I   
outlets power up immediately, followed   
four seconds later by SW-II outlets  

 

which is followed four seconds later by   
the sequenced remote I/O port.

•

Add “/MTD” after part number, i.e. 
TPC115-10-A/MTD

•

3 front/2 rear

•

Remote on/off and EPO control, EPO    
overrides remote and local control

•

Sequence Power Up additional 
equipment down line (3rd connector on 
front panel)

•

Latching remote feature - (N/C) EPO,    
momentary start

–

Add “-LT” to the part number when 

  

the MTD feature is not being used

–

Add “/LT” to the part number  

 

when the MTD feature is used