Sony DSCS780 Manual

Page of 64
29
GB
Troubleshooting
If you experience trouble with your camera, try the following solutions.
Be aware that by sending the camera for repair, you give consent that the contents of the 
internal memory may be checked.
Cannot insert the battery pack.
Insert the battery pack correctly to push the battery eject lever (page 11).
Cannot turn on the camera.
After inserting the battery pack into the camera, it may take a few moments for the camera to 
power up.
Insert the battery pack correctly (page 11).
The battery pack is discharged. Insert charged battery pack (page 10).
The battery pack is dead. Replace it with a new one.
Use a recommended battery pack.
The power turns off suddenly.
If you do not operate the camera for about three minutes while the power is on, the camera 
turns off automatically to prevent wearing down the battery pack. Turn on the camera again 
(page 13).
The battery pack is dead. Replace it with a new one.
The remaining charge indicator is incorrect.
This phenomenon occurs when you use the camera in an extremely hot or cold location.
A discrepancy arose between the remaining charge indicator and the actual remaining battery 
charge. Fully discharge the battery pack once, then charge it to correct the indication.
The battery pack is discharged. Insert the charged battery pack (page 10).
The battery pack is dead. Replace it with a new one.
1
Check the items below, and refer to “Cyber-shot Handbook” (PDF).
2
Remove the battery pack, wait for about one minute, re-insert the battery 
pack, then turn on the power.
3
Initialize the settings (page 23).
4
Consult your Sony dealer or local authorized Sony service facility.
Battery pack and power