Sony SDM-S95ER Manual

10

• If “OUT OF RANGE” appears on the screen:

Reconnect the old display. Then adjust the computer’s graphics 
board within the following ranges.

For more information about the on-screen messages, see “Trouble 
symptoms and remedies” on page 18.

No need for specific drivers
The display complies with the “DDC” Plug & Play standard and 
automatically detects all the display’s information. No specific driver 
needs to be installed to the computer.
The first time you turn on your computer after connecting the display, the 
setup Wizard may appear on the screen. If this is the case, follow the on-
screen instructions. The Plug & Play display is automatically selected so 
that you can use this display. 

The vertical frequency turns to 60 Hz. 
Since flickers are unobtrusive on the display, you can use it as is. You do 
not need to set the vertical frequency to any particular high value.

This display can be adjusted within the angles shown below.

When you use the height adjustable stand, the height adjust is also 
available as below.

Adjust the viewing angle of your display according to the height 
of your desk and chair, so that light is not reflected from the screen 
to your eyes.

Notes
• When adjusting the screen’s angle, be sure not to crash it against any 

objects around the display.

• Do not put any objects under the display when you adjust the height of 

stand. It may get damaged by accident.

28–80 kHz

28–64 kHz

48–75 Hz

60 Hz

1280 

× 1024 or less

approx. 5°

approx. 20°

approx. 175°

approx. 
175°

approx. 110 mm 
(4 

11

/

32

 inches)