Sony DR-AS22iP Manual

4-270-383-11(1)

©2011   Sony Corporation 

Printed in Thailand

DR-AS22iP

Stereo Headset

Operating Instructions

Manual de instrucciones

High volume may affect your hearing. 

For traffic safety, do not use while 

driving or cycling.



  Do not leave the stereo headphones in a location 

subject to direct sunlight, heat or moisture.



  Do not wash the headphones.



  Though this headphones is water resistant design, 

avoid exposing the headphones to excessive water or 

sweat. Water or sweat entering the headphones may 

damage them. If the sound from the headphones 

becomes low or stops, leave the headphones to dry 

out.

Static electricity accumulated in the body may cause 

mild tingling in your ears.

To minimise the effect, wear clothes made from natural 

materials.

You can use the unit with only the following models 

supporting remote control. Update your iPod, iPhone 

or iPad to the latest software before use. In the 

Operating Instructions, iPod, iPhone and iPad are 

collectively described as “iPod” except in special cases.



  iPod touch 4th generation



  iPod touch 3rd generation



  iPod touch 2nd generation



  iPod nano 6th generation



  iPod nano 5th generation (video camera)



  iPod nano 4th generation (video)



  iPod classic 120GB 160GB (2009)



  iPod shuffle 4th generation



  iPod shuffle 3rd generation



  iPhone 4



  iPhone 3GS



  iPad 2



  iPad

iPhone

®

, iPod

®

, iPod classic

®

, iPod nano

®

, iPod 

shuffle

®

, and iPod touch

®

 are trademarks of Apple 

Inc., registered in the U.S. and other countries. iPad

®

 is 

a trademark of Apple Inc.
“Made for iPod,” “Made for iPhone,” and “Made for 

iPad” mean that an electronic accessory has been 

designed to connect specifically to iPod, iPhone, or 

iPad, respectively, and has been certified by the 

developer to meet Apple performance standards. Apple 

is not responsible for the operation of this device or its 

compliance with safety and regulatory standards.

Plays/pauses a track of the connected iPod product 

with a single press. Skips to the next track with a double 

press. Skips to the previous track with a triple press. 

Starts the “VoiceOver*” feature with a long press (if 

available).

Press once to answer the call. Press again to end. Hold 

down for about two seconds to reject an incoming call. 

When you let go, two low beeps confirm the call was 

rejected.
*  Availability of the “VoiceOver” feature depends on 

iPod and its software version.

Be careful not to unintentionally press any buttons 

when you carry your iPod with this unit connected.

Type: Open, dynamic

Driver unit: 13.5 mm, dome type (CCAW adopted)

Power handling capacity: 50 mW (IEC*)

Impedance: 16 Ω at 1 kHz

Sensitivity: 104 dB/mW

Frequency response: 17 Hz – 22,000 Hz

Cord: 1.2 m (47 

1

/

4

 in), Y-type

Plug: Four-conductor gold-plated L-shaped stereo 

mini plug for iPod and iPhone with remote function

Mass: Approx. 12 g (0.43 oz) (without cord)

Open circuit voltage level: – 42 dB (0 dB=1 V/Pa)

Clip (1)

*  IEC = International Electrotechnical Commission

Design and specifications are subject to change without 

notice.

You are cautioned that any changes or modifications 

not expressly approved in this manual could void your 

authority to operate this equipment.

Volume +

*

Center button

Volume –

Microphone

*  There is a tactile dot 

beside Volume +.