Sony XBA-3iP Manual

qualified personnel only.
You are cautioned that any changes or modifications not expressly approved in this 

manual could void your authority to operate this equipment.

You can use the unit with only the following models supporting remote control. Update 

your iPod, iPhone or iPad to the latest software before use. In the Operating Instructions, 

iPod, iPhone and iPad are collectively described as “iPod” except in special cases.

  iPod touch 4th generation

  iPod touch 3rd generation

  iPod touch 2nd generation

  iPod nano 6th generation

  iPod nano 5th generation (video camera)

  iPod nano 4th generation (video)

  iPod classic 120GB 160GB (2009)

  iPod shuffle 4th generation

  iPod shuffle 3rd generation

  iPhone 4

  iPhone 3GS

  iPad 2

  iPad

iPhone®, iPod®, iPod classic®, iPod nano®, iPod shuffle®, and iPod touch® are trademarks 

of Apple Inc., registered in the U.S. and other countries. iPad® is a trademark of Apple 

Inc.

“Made for iPod,” “Made for iPhone,” and “Made for iPad” mean that an electronic 

accessory has been designed to connect specifically to iPod, iPhone, or iPad, respectively, 

and has been certified by the developer to meet Apple performance standards. Apple is 

not responsible for the operation of this device or its compliance with safety and 

regulatory standards.

  Earbuds with remote controller for iPod/iPhone/iPad 

Easy-to-use remote control (only for iPod, iPhone and iPad)

  Newly developed Triple Balanced Armature driver unit 

Newly developed micro-size driver unit (full-range + woofer + tweeter) reproduces 

smooth and clear vocal, with rich, powerful bass and detailed high range.

  Newly developed Double Layered Housing 

Magnesium inner housing holds the driver units rigidly for smooth sound response. 

Special ABS plastic outer housing prevents unwanted vibration for clear mid-high 

range.

  Noise-blocking design 

Noise-blocking design attenuates ambient noise and sound leakage.

  Super-small body 

Balanced Armature driver unit allows for a super small body, and ultimate wearing 

comfort.

Using the supplied cord adjuster (see fig. -)

You can adjust the cord length by winding the cord on the cord adjuster.

(The cord can be wound to the cord adjuster up to 50 cm. If you wind more, the cord 

comes off from the cord adjuster easily.)

Do not wind the plug or split section of the cord, as it will strain the cord and may cause a wire break.

-)

You can control a connected iPod product.

 Volume +

Increases the volume of the connected iPod product. 

 Center button

Plays/pauses a track of the connected iPod product with a single press. Skips to the next 

track with a double press. Skips to the previous track with a triple press. Starts the 

“VoiceOver*” feature with a long press (if available).

Press once to answer the call. Press again to end.

Hold down for about two seconds to reject an incoming call.

When you let go, two low beeps confirm the call was rejected.

 Volume –

Decreases the volume of the connected iPod product.

 Microphone

* Availability of the “VoiceOver” feature depends on iPod and its software version.

Wearing the headphones (see fig. )
1 

There is a tactile dot on the unit marked  to distinguish the left side.

Installing the earbuds correctly (see fig. )

If the earbuds do not fit your ears correctly, low-bass sound may not be heard. To enjoy 

better sound quality, change the earbuds to another size or type, or adjust the earbuds 

position to sit on your ears comfortably and fit your ears snugly. If the earbuds do not fit 

your ears, try another size or type. Confirm the size of the earbuds by checking the color 

inside (see fig. - for hybrid silicone rubber earbuds and - for noise isolation 

earbuds).

When you change the earbuds, install them firmly on the headphones to prevent the 

earbud from detaching and remaining in your ear.

About hybrid silicone rubber earbuds (see fig. -)

Small 



Large 



SS 

(Red)

S 

(Orange)

M 

(Green)

L 

(Light blue)

Remove the earbuds from the headphones, and wash them with a mild detergent 

solution.

About noise isolation earbuds (see fig. -)

Supplied noise isolation earbuds provides a snug fit for effective attenuation of ambient 

noise.

Small 



Large 



S 

(Orange)

M 

(Green)

L 

(Light blue)



 Prolonged use of the noise isolation earbuds may strain your ears due to their snug fit. If you have 

experience discomfort or pain in your ears, discontinue use.



 The pressure-relieving urethane cushion is extremely soft. Therefore, do not pinch or pull the 

urethane cushion. If the urethane cushion is broken or detached from the earbuds, it will not take its 

correct position and the earbuds will lose their noise isolation function.



 The pressure-relieving urethane cushion may deteriorate due to long-term storage or use. If the 

pressure-relieving power is lost and the urethane cushion becomes hard, the earbuds may lose their 

noise isolation function.



 Do not wash the noise isolation earbuds. Keep them dry, and avoid accumulation of water in the 

pressure-relieving urethane-cushions. Not doing so may cause early deterioration.







*





* There is a tactile dot beside 

Volume +.



Earbud

Tactile dot







Colored parts

Pressure-relieving 

urethane cushion









XBA-3iP

Stereo Headset

Operating Instructions
Manual de instrucciones

4-408-903-11(1)

©2011   Sony Corporation 

Printed in Thailand

To detach an earbud (see fig. -)

While holding the headphone, twist the parts inside of the earbud and pull the earbud 

off.

 Tip

If the earbud slips and cannot be detached, wrap it in a dry soft cloth.

To attach an earbud (see fig. -)

Push the parts inside of the earbud into the headphone until the projecting part of the 

headphone is fully covered.

How to attach the clip to the cord (see fig. )
1 



 If you pull up the lever on the clip without holding the clip closed, or holding the clip closed but 

opening the lever too much, you cannot put the cord into the groove under the lever.



 Do not catch the cord on the projection of the clip or do not wedge it into the groove. It may damage 

the wires of the cord. 



 Do not move the clip position with the cord attached. It may damage the wires of the cord. 

After use, remove the headphones slowly.

Headphones are designed to fit closely in your ears. If the headphones are pressed hard while in use or 

taken off too quickly, they may cause injury.

Wearing headphones may produce a diaphragm click sound. This is not a malfunction.

Closed, Triple Balanced Armature

Triple Balanced Armature

100 mW (IEC*)

12 Ω at 1 kHz

108 dB**

4 Hz – 28,000 Hz

1.2 m (47 

1

/

4

  in) (Y-type)

Four-conductor gold-plated L-shaped stereo mini 

plug for iPod with remote function

Approx. 7 g (0.25  oz) (without cord)

– 42 dB (0 dB=1 V/Pa)

Hybrid silicone rubber earbuds: SS (red) (2), S (orange) (2), M (green) (attached to the 

unit at the factory) (2), L (light blue) (2)

Noise isolation earbuds: S (orange) (2), M (green) (2), L (light blue) (2)

Cord adjuster (winds cord up to 50 cm (19 

3

/

4

  in)) (1)

Clip (1)

Carrying case (1)

Operating Instructions (1)

*  IEC = International Electrotechnical Commission

** 150 mV input

Design and specifications are subject to change without notice.

  Please keep your headphones clean at all times especially inside the rubber earbud. 

(see fig. ) 

If any dust or ear wax is inside the earbud, you may experience some listening 

difficulties.

  Listening with headphones at high volume may affect your hearing. For traffic safety, 

do not use while driving or cycling.

  Handle the driver units carefully.

  Do not put weight or pressure on the headphones as it may cause the headphones to 

deform during long storage.

  The earbuds may deteriorate due to long-term storage or use.

  Install the earbuds firmly onto the headphones. If an earbud accidentally detaches and 

is left in your ear, it may cause injury.

  Store the earbuds where children cannot reach in order to prevent from accidental 

ingestion or choking.

  Do not leave the stereo headphones in a location subject to direct sunlight, heat or 

moisture.

  Be careful not to unintentionally press any buttons when you carry your iPod with this 

unit connected.

In particularly dry air conditions, mild tingling may be felt on your ears. This is a result 

of static electricity accumulated in the body, and not a malfunction of the headphones.

The effect can be minimized by wearing clothes made from natural materials.

Optional replacement earbuds can be ordered from your nearest authorized Sony 

retailer or www.sony.com.