Sony VPL-HW15 Manual

Page of 84
 
10
This section describes how to install the projector and screen, how to connect the 
equipment from which you want to project the picture, etc.
Unpacking
Check the carton to make sure it contains the following items:
Inserting the batteries into the remote control
CAUTION
Danger of explosion if battery is incorrectly replaced. 
Replace only with the same or equivalent type recommended by the manufacturer. 
When you dispose of the battery, you must obey the law in the relative area or country.
Installing batteries
Two size AA (R6) batteries are supplied for Remote Control.
To avoid risk of explosion, use size AA (R6) manganese or alkaline batteries.
Caution about handling the remote control
• Handle the remote control with care. Do not drop or step on it, or spill liquid of any kind 
onto it.
• Do not place the remote in a location near a heat source, a place subject to direct 
sunlight, or a damp room.
Connections and Preparations
• Remote control (1) and 
Size AA (R6) manganese batteries (2)
• AC power cord (1)
• Lens cap (1)
When you have purchased the projector, 
the lens cap is put onto the lens. 
Remove this lens cap when you use the 
projector.
• Operating Instructions (this manual)
Insert the batteries E side first as shown in the illustration.
Inserting them forcibly or with the polarities reversed may 
cause a short circuit and may generate heat.
Push and slide to open.