Sony AIR-SA20PK Manual

Page of 2
AIR-SA20PK (GB/FR) 4-119-532-21(1)
©2008 Sony Corporation   Printed in China
4-119-532-21(1)
English
To stabilize S-AIR reception
Read the following when S-AIR reception is poor or unstable.
To use S-AIR products (S-AIR main unit and sub unit)
Before using S-AIR products, have the following ready.
Confirm the wireless transceivers are inserted 
correctly.
Insert the wireless transceivers firmly to the depth 
into the slots of the S-AIR main unit and sub unit 
respectively.
Confirm that the S-AIR IDs of the S-AIR main unit 
and sub unit are the same. 
The default setting of the S-AIR IDs of the S-AIR 
main unit and sub unit is “A.”  
Depending on the S-AIR product, you can set the 
S-AIR ID by the switch or the setup menu.  
For details, refer to the operating instructions of 
each S-AIR product.
About environments where S-AIR products (S-AIR main unit and sub 
unit) are used
S-AIR products use a radio frequency of 2.4 GHz. Certain electronic equipment or other factors may 
cause lost connection or instability in S-AIR reception.
Electronic equipment influence
The following may cause interference or cross talk.
Cellular phones, cordless phones
Wireless LAN, personal computers
Game machines using radio signals
Microwave ovens
Other factors
The following may cause poor reception.
Materials or structures, such as walls and floors
The location where an S-AIR product is placed
When using S-AIR products, place them as far as possible from the above electronic equipment, or 
place where S-AIR reception is stable. 
When S-AIR reception is poor
Check the following.
Keep cords that are connected to the S-AIR product (power supply cord, power cord, antennas or 
other cords) away from the wireless transceiver and slot.
Keep as much space as possible around S-AIR products.
Avoid placing S-AIR products on top of, or directly below, other electronic equipment.
Avoid placing S-AIR products in a closed rack, metal rack, or under a table.
Adjust the location (height, orientation, and place in the room) of S-AIR products until reception is 
the most stable.
Place so that the wireless transceivers of the S-AIR main unit and sub unit are closer.
Place so that S-AIR products are separated from other wireless devices.
Place so that S-AIR products are separated from metal doors or tables.
If you cannot improve S-AIR reception, change the “RF CHANGE” setting. For details, refer to the 
operating instructions of each S-AIR product.
Insert firmly
Same S-AIR ID