Sony RM-AV2500 Manual
27
Programming a series of
commands to the Component
Select buttons
commands to the Component
Select buttons
As with the SYSTEM CONTROL buttons,
you can also program a series of
operating commands for the Component
Select buttons (up to 32 steps).
To execute the commands programmed
on a Component Select button by the
System Control function, press the button
for more than 2 seconds.
you can also program a series of
operating commands for the Component
Select buttons (up to 32 steps).
To execute the commands programmed
on a Component Select button by the
System Control function, press the button
for more than 2 seconds.
Notes
• The programmed commands are executed
when you press a Component Select button
for more than 2 seconds. When you press the
button for less than 2 seconds, it works as the
normal Component Select button, and the
corresponding touch-keys are displayed.
for more than 2 seconds. When you press the
button for less than 2 seconds, it works as the
normal Component Select button, and the
corresponding touch-keys are displayed.
• See also “Tips for programming the System
Control functions” on page 25 and “Notes on
System Control Operations” on page 27.
System Control Operations” on page 27.
MENU
EXIT
SYSTEM CONTROL
MUTING
LIGHT
COMMANDER OFF
RECALL
TV
AMP
CD
CBL
SAT
MD
DVR
TAPE
VCR
DVD
M1
M2
CHANNEL
VOLUME
OK
A
B
C
MORE
1
Notes on System Control
Operations
Operations
•If the remote control detectors of the
components are too far apart, or if
something is blocking them, some of
the components may not operate
consecutively even after you press the
SYSTEM CONTROL button.
something is blocking them, some of
the components may not operate
consecutively even after you press the
SYSTEM CONTROL button.
•If some of the components did not
operate correctly because of the above
or for any other reason, always set all
the components back to the states they
were in before you pressed the SYSTEM
CONTROL button. Failure to do this
can result in incorrect operation when
you press the SYSTEM CONTROL
button again.
or for any other reason, always set all
the components back to the states they
were in before you pressed the SYSTEM
CONTROL button. Failure to do this
can result in incorrect operation when
you press the SYSTEM CONTROL
button again.
•Some components may not always be
powered on by the System Control
function. This is because the power of
the component gets on and off
alternatively when receiving the power
on/off signal. In this case, check the
operating component’s power on/off
state before using the system control
function.
function. This is because the power of
the component gets on and off
alternatively when receiving the power
on/off signal. In this case, check the
operating component’s power on/off
state before using the system control
function.
•If the system control function does not
work correctly, see also “Tips for
programming the System Control
functions” on page 25.
programming the System Control
functions” on page 25.
Continued