Sony RM-AV2500 Manual
38
Transferring Data between Remote
Commanders (continued)
Commanders (continued)
1
Place the RM-AV2500 head to
head with another remote
commander.
head with another remote
commander.
2
While pressing COMMANDER
OFF, press CHANNEL – and
VOLUME –.
OFF, press CHANNEL – and
VOLUME –.
3
Press the
R button.
R: Transfer data
r: Receive data
r: Receive data
4
Press the 1 key.
1: All data of the Commander
2: Data of a Component Select button
2: Data of a Component Select button
5
Confirm that the receiving remote
commander is ready for data.
commander is ready for data.
(To set the receiving commander,
follow the procedure on page 40.)
follow the procedure on page 40.)
6
Press the “ENTER” key.
As the data is transferred, the
corresponding component name goes
off. If the all data has been
successfully transferred, the backlight
of the display turns off.
corresponding component name goes
off. If the all data has been
successfully transferred, the backlight
of the display turns off.
Note
If “NG” appears while sending the data, go
back to Step 5 and continue the operation
or press COMMANDER OFF to stop the
operation.
back to Step 5 and continue the operation
or press COMMANDER OFF to stop the
operation.
Note
Be sure that the receiving remote commander is
ready to receive data.
ready to receive data.
Another remote commander
about 2 – 4 inches
(5 – 10 cm) away
(5 – 10 cm) away
RM-AV2500