Sony SU-WL51 User Guide

10 

(GB)

1

Insert the screws (+B6×L20, supplied) into the 
screw holes on the outer left and right sides of the 
Mounting Hook Unit support shafts, and tighten 
them temporarily.

If the temporarily attached screws protrude inside the 
Mounting Hook Unit support shafts, the lower hooks of the 
Mounting Hook Unit cannot be fitted in (procedure 4).

2

Hitch the upper hooks of the two Mounting Hook 
Units on to the support shafts of the arms.

3

Place the lower hooks of the two Mounting Hook 
Units so that they touch the front side of the 
Mounting Hook Unit support shafts.

4

Slightly push the TV or monitor toward the Plate 
Unit and upward, to hitch the lower hooks of the 
two Mounting Hook Units to the Mounting Hook 
Unit support shafts.

5

Confirm the eight hooks are firmly hooked on the 
four shafts on the Plate Unit.

Tighten the screws 
to halfway so that 
they do not 
protrude from the 
opposite side.

6

Firmly tighten the securing screws screwed in 
temporarily in procedure 1.

Be sure to tighten both left and right securing screws 
firmly. If you fail to do so, the TV or monitor may fall 
when it is pushed upward and cause injury.

• The eight hooks of the Mounting Hook Units are 

firmly hooked on the four shafts of the Plate Unit.

• The cord and the cable are not twisted or pinched.
• The two securing screws on the Mounting Hook 

Unit are securely tightened.

Incomplete installation may cause the product falling and 
result in injury or product damage. Also, improper 
placement of the AC power cord, etc., may cause fire or 
electric shock through a short circuit.
Be sure to confirm the completion of the installation for 
safety.

01GB01COV.book  Page 10  Tuesday, December 20, 2005  4:59 PM