Sony KDF-50E3000 Quick Setup Guide

KDF-46/50E3000 EN 3-210-794-11(1)

Your TV is equipped with two HDMI inputs, connect your incoming signal source (HD Cable Box, HD Satellite Receiver, or DVD) with an HDMI or component video for the best 

possible picture quality.

If your connecting equipment has DVI output instead of the HDMI output, you must use DVI-to-HDMI cable for the video and also connect an audio cable for the sound. If this is  

the case, connect the cable to HDMI IN 2 (input) of your TV.

When receiving High Definition content signal by over-the-air antenna, it is best to use the HD antenna.

When using a DVI-to-HDMI cable, make sure to connect the DVI side first.

■
■
■

■

Cable/Antenna

Splitter

Blu-ray Disc™/DVD

Rear of TV

SAT 

(dish)

HD Cable Box  

or HD Satellite 

Receiver

A/V Receiver

Cable/Antenna

Splitter

Rear of TV

DVD/VCR Combo

VCR

DVD

Cable/Antenna

Splitter

Rear of TV

SAT 
(dish)

HD Cable Box or 
HD Satellite Receiver

Notebook PC

Cable/Antenna

Splitter

Blu-ray Disc™/DVD

SAT 
(dish)

HD Cable Box 
or HD Satellite 
Receiver

Rear of TV

PC

HD Antenna

Blu-ray Disc™/DVD

Cable/SAT (dish)

SD Cable Box or  
SD Satellite Receiver

Home Theater System

Plus

Rear of TV

Or

Coaxial

HDMI

DVI-to-HDMI

Component

Composite

Audio (L/R)

Digital Optical Audio

Or

BD

101 (Sony Blu-ray Disc Player)

DVD

751 (Sony DVD Player)

STB

801 (Sony Satellite Receiver)

Follow the steps below to program your TV’s remote control.

   In the space provided below, write down the three-digit code of your equipment found on 

the Manufacturer’s Codes List on page 26 of the Operating Instruction Manual.

   If more than one code is listed, try entering the code listed first.

  Code No. ______________

   Press and hold 

, 

 or 

 and 

 simultaneously to light the FUNCTION button.

   Enter the three-digit code using  -  while the selected button is lit. If the code is not 

entered within 10 seconds, you must repeat step 2.

   Press   while the FUNCTION button is lit. 

If programmed correctly the selected FUNCTION button blinks twice. If not it blinks five times.

If you can turn on and off the equipment by pressing the green   button, then the programming 

is complete. If not, try the next code listed.

Note:

 In some cases, you may not be able to program your remote control. If this is the case, use 

your equipment’s own remote control.

 Any one of the FUNCTION buttons can be programmed to operate other equipment 

regardless of the labeling. For example, if programmed with the correct code, 

 can 

operate DVD/VCR combo equipment. This is useful if your equipment does not match 

the labeled buttons available. Make note of your equipment’s programmed button.

■
■