Sony BDP-S360HP Manual

Page of 79
3
Notes About the Discs
• To keep the disc clean, handle 
the disc by its edge. Do not 
touch the surface. 
Dust, fingerprints, or scratches 
on the disc may cause it to 
malfunction.
• Do not expose the disc to 
direct sunlight or heat sources 
such as hot air ducts, or leave it 
in a car parked in direct 
sunlight as the temperature 
may rise considerably inside 
the car.
• After playing, store the disc in 
its case.
• Clean the disc with a cleaning 
cloth. Wipe the disc from the 
center out.
• Do not use solvents such as 
benzine, thinner, 
commercially available disc/
lens cleaners, or anti-static 
spray intended for vinyl LPs.
• If you have printed the disc’s 
label, dry the label before 
playing.
• Do not use the following discs.
– A lens cleaning disc.
– A disc that has a non-
standard shape (e.g., card, 
heart).
– A disc with a label or sticker 
on it.
– A disc that has cellophane 
tape or sticker adhesive on it.
• Do not resurface the playing 
side of a disc to remove 
surface scratches.
Precautions
The power requirements and 
power consumption of this 
player are indicated on the back 
of the player. Check that the 
player’s operating voltage is 
identical with your local power 
supply.
Power requirements and 
power consumption
m
On safety
• To prevent fire or shock 
hazard, do not place objects 
filled with liquids, such as 
vases, on the player, or place 
the player near water, such as 
near a bathtub or shower room. 
Should any solid object or 
liquid fall into the cabinet, 
unplug the player and have it 
checked by qualified 
personnel before operating it 
any further.
• Do not touch the AC power 
cord with wet hands. Doing so 
may cause an electric shock.
On placement
• Place the player in a location 
with adequate ventilation to 
prevent heat build-up in the 
player.
• Do not place the player on a 
soft surface such as a rug that 
might block the ventilation 
holes.
• Do not install this player in a 
confined space, such as a 
bookshelf or similar unit.
• Do not place the player in a 
location near heat sources, or 
in a place subject to direct 
sunlight, excessive dust, or 
mechanical shock.
• Do not place the player 
outdoors, in vehicles, on ships, 
or on other vessels.
• If the player is brought directly 
from a cold to a warm location, 
or is placed in a very damp 
room, moisture may condense 
on the lenses inside the player. 
Should this occur, the player 
may not operate properly. In 
this case, remove the disc and 
leave the player turned on for 
about half an hour until the 
moisture evaporates.
• Do not install the player in an 
inclined position. It is 
designed to be operated in a 
horizontal position only.
• Keep the player and the discs 
away from equipment with 
strong magnets, such as 
microwave ovens, or large 
loudspeakers.
• Do not place heavy or unstable 
objects on the player.
• Do not place any objects other 
than discs on the disc tray. 
Doing so may cause damage to 
the player or the object.
• When you move the player, 
take out any discs. If you 
don’t, the disc may be 
damaged.
• When you move the player, 
disconnect the AC power cord 
and all other cables from the 
player.
On power sources
• The player is not disconnected 
from the AC power source as 
long as it is connected to the 
wall outlet, even if the player 
itself has been turned off.
• If you are not going to use the 
player for a long time, be sure 
to disconnect the player from 
the wall outlet. To disconnect 
the AC power cord, grasp the 
plug itself; never pull the cord.
• Observe following points to 
prevent the AC power cord 
being damaged. Do not use the 
AC power cord if it is 
damaged, as doing so may 
result in an electric shock or 
fire.
– Do not pinch the AC power 
cord between the player and 
wall, shelf, etc.
– Do not put anything heavy 
on the AC power cord or pull 
on the AC power cord itself.
,continued