Sony kdl-52wl130 Manual

KDL-52WL130 EN 3-272-407-11(1)

Your TV is equipped with three HDMI inputs, connect your incoming signal source (HD Cable Box, HD Satellite Receiver, or DVD) with an HDMI or component video for the best 

possible picture quality.

If your connecting equipment has DVI output instead of the HDMI output, you must use DVI-to-HDMI cable for the video and also connect an audio cable for the sound. If this is the 

case, connect the cable to HDMI IN 1 (input) of your TV.

P&P/PIP functions require VHF/UHF/CABLE connection.

When receiving High-Definition content signal by over-the-air antenna, it is best to use the HD antenna.

When using a DVI-to-HDMI cable, make sure to connect the DVI side first.

■
■
■

■

■

HD Antenna

Blu-ray Disc™/DVD

Cable/SAT (dish)

SD Cable Box or  

SD Satellite Receiver

Home Theater System

Or

Rear of TV

Cable/Antenna

Splitter

Blu-ray Disc™/DVD

SAT 

(dish)

HD Cable Box 

or HD Satellite 

Receiver

Cable/Antenna

Splitter

Rear of TV

VCR/DVD Combo

VCR

DVD

Cable/Antenna

Splitter

Blu-ray Disc™/DVD

Rear of TV

SAT 

(dish)

HD Cable Box  

or HD Satellite 

Receiver

A/V Receiver

Rear of TV

Cable/Antenna

Splitter

Rear of TV

SAT 

(dish)

HD Cable Box or 

HD Satellite Receiver

Notebook PC

Coaxial

HDMI

DVI-to-HDMI

Component

Composite

Audio (L/R)

Mini-Pin Audio

Digital Optical Audio

Audio (L/R) with Mini-Pin

HD15

BD

101 (Sony Blu-ray Disc Player)

DVD

751 (Sony DVD Player)

STB

801 (Sony Satellite Receiver) 

Follow the steps below to program your TV’s remote control.

  

In the space provided below, write down the three-digit code of your equipment 

found on the Manufacturer’s Codes List (see Operating Instructions). 

If more than one code is listed, try entering the code listed first. 

Code No. ______________

  

Press and hold 

, 

 or 

 and 

 simultaneously to light the FUNCTION 

button. 

  

Enter the three-digit code using - while the selected button is lit.  If the code is 

not entered within 10 seconds, you must repeat step 2.

  

Press   while the FUNCTION button is lit. 

If programmed correctly the selected FUNCTION button blinks twice. If not it blinks 

five times.

If you can turn on and off the equipment by pressing the green 

 button, then the 

programming is complete. If not, try the next code listed.

In some cases, you may not be able to program your remote control.  If this is the 

case, use your equipment’s own remote control.

Any one of the FUNCTION buttons can be programmed to operate other 

equipment regardless of the labeling.  For example, if programmed with the correct 

code, 

 can operate DVD/VCR combo equipment.  This is useful if your 

equipment does not match the labeled buttons available.  Make note of your 

equipment’s programmed button.

■
■

PC