Fujitsu S26361-F2735-L130 User Manual
Product Facts
⏐ Issue: March 25, 2008 ⏐ Product: PRIMERGY rack systems Design guide
Page 43 / 89
8.1.2
Mounting the system on telescopic rails (installation examples)
There are three primary ways of mounting systems on telescopic rails:
1. Sliding the system onto a system support plate and securing it.
2. Screwing the system directly to the inner telescopic rail. In this case, you replace the system by separating the rails.
3. There are shoulder screws on the system housing which engage in the keyholes of the inner telescopic rail.
2. Screwing the system directly to the inner telescopic rail. In this case, you replace the system by separating the rails.
3. There are shoulder screws on the system housing which engage in the keyholes of the inner telescopic rail.
System mounted on system support plates (high safety during mounting!)
System screwed directly to the telescopic rail
System with shoulder screw for keyhole engagement / KEYHOLE
Shoulder screw M4 Torx T20 A3C40071737
8.1.3
Basics of the structural design of the carrier systems for FSC, Fujitsu and third-party racks
A basic requirement for designing carrier systems is compliance with the EIA-310-D 19-inch standard and information on the
different carrier profiles on the market.
different carrier profiles on the market.
FSC PCR rack and most third-party racks
Front plate 4U
Ttelescopic rail
System support
System housing
Front plate 4U
Telescopic rail
System housing
Front plate 4U
Telescopic rail
System housing
Shoulder screw M4
Torx T20