Sony XAV-W650BT Manual

GB

THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT 
HOLDERS AND CONTRIBUTORS “AS IS” AND ANY 
EXPRESS OR IMPLIED WARRANTIES, INCLUDING, 
BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF 
MERCHANTABILITY AND FITNESS FOR A 
PARTICULAR PURPOSE ARE DISCLAIMED. IN NO 
EVENT SHALL THE FOUNDATION OR CONTRIBUTORS 
BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL, 
SPECIAL, EXEMPLARY, OR CONSEQUENTIAL 
DAMAGES (INCLUDING, BUT NOT LIMITED TO, 
PROCUREMENT OF SUBSTITUTE GOODS OR 
SERVICES; LOSS OF USE, DATA, OR PROFITS; OR 
BUSINESS INTERRUPTION) HOWEVER CAUSED AND 
ON ANY THEORY OF LIABILITY, WHETHER IN 
CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING 
NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY 
OUT OF THE USE OF THIS SOFTWARE, EVEN IF 
ADVISED OF THE POSSIBILITY OF SUCH DAMAGE.

This product uses font data which is licensed to 
Sony owned by Monotype Imaging Inc.
Such font data shall be used solely in connection 
with this product.

All other trademarks are trademarks of their 
respective owners.

The following checklist will help you remedy 
problems you may encounter with your unit.
Before going through the checklist below, check 
the connection and operating procedures.
For details on using the fuse and removing the unit 
from the dashboard, see “Connection/Installation” 
(page 33).
If the problem is not solved, visit the support site on 
the back cover.

No power is being supplied to the unit.
 Check the fuse.

 The connection is not correct.

 Connect the yellow and red power supply 

leads.

There is no beep sound.
 An optional power amplifier is connected and 

you are not using the built-in amplifier.

The contents of the memory have been erased.
 The power supply lead or battery has been 

disconnected or it is not connected properly.

Stored stations and correct time are erased.
The fuse has blown.
The unit makes noise when the position of the 
ignition is switched.
 The leads are not matched correctly with the car’s 

accessory power connector.

The display disappears from/does not appear on 
the monitor.
 The dimmer is set to [ON] (page 19).

 The display disappears if you press and hold 

HOME.
 Press HOME on the unit until the display 

appears.

 The monitor off function is activated (page 20).

 Touch anywhere on the display to turn the 

display back on.

The display does not respond to your touch 
correctly.
 Touch one part of the display at a time. If two or 

more parts are touched simultaneously, the 
display will not operate correctly.

 Calibrate the touch panel of the display (page 19).

 Touch the pressure sensitive panel firmly.

 The rear monitor cannot be operated. Icons 

displayed on the rear monitor are disabled.

Menu items cannot be selected.
 Unavailable menu items are displayed in gray.

The stations cannot be received.
The sound is hampered by noise.
 The connection is not correct.

 Connect the REM OUT lead (blue/white striped) 

or accessory power supply lead (red) to the 
power supply lead of a car’s antenna (aerial) 
booster (only when your car has built-in radio 
antenna (aerial) in the rear/side glass).

 Check the connection of the car antenna 

(aerial).

 If the auto antenna (aerial) will not extend, 

check the connection of the power antenna 
(aerial) control lead.

Preset tuning is not possible.
 The broadcast signal is too weak.

PTY displays [PTY not found.].
 The current station is not RDS station.

 RDS data has not been received.

 The station does not specify the program type.

There is no picture/picture noise occurs.
 A connection has not been made correctly.

 Check the connection between this unit and 

other equipment and set the input selector of the 
equipment to the source corresponding to this 
unit.

 The disc is defective or dirty (XAV-W650BT).