Sony DMX-DVD Manual

With the bracket fully extended, insert the guide 
pins on the bracket into the guide holes on the TV. 
The holes on the bracket should align to the holes on 
the TV.

Insert the 2 plastic fasteners (supplied) into the 
holes, then press in the head of the fasteners until 
they click.

~

Do not push on the head of the plastic fastener until you 
have inserted it into the hole on the TV.

Slide the bracket so that the viewing window covers 
the corresponding number (see the illustrations and 
table on the previous page). If the viewing window 
indicates Bracket Setting 2, be sure to use a Velcro 
strip (supplied); see previous page.

Align the slider on the bottom of the receiver unit 
with the groove of the installation bracket.

Slide down the DVD player onto the bracket with 
the DVD slot facing the outer edge of the TV. Before 
proceeding to the next step, make sure that you are 
satisfied with the position of the DVD player in 
relation to the TV.

Secure the location of the sliding bracket by 
screwing the Thumb Screw into the screw point 
located just beneath the viewing window. If Bracket 
Setting 2 is used,  peel off the arrow label by pulling 
downwards, and firmly press the bracket onto the 
TV.

PULL

Plastic Fasteners

Arrow Label

Thumb Screw

PULL

PULL