Sony HCD-GX8800 Manual
MHC-GN800 4-244-569-11 (1)
18
GB
Recording a CD by specifying
track order
track order
— Program Edit
You can record tracks from all the CDs in the
order you want. When programing, make sure
the playing times for each side do not exceed
the length of one side of the tape.
order you want. When programing, make sure
the playing times for each side do not exceed
the length of one side of the tape.
1
Insert a recordable tape into deck B,
then press CD.
then press CD.
2
Press PLAY MODE repeatedly until
“PGM” lights up in the display.
“PGM” lights up in the display.
3
Press one of the DISC 1~3 button to
select a CD.
select a CD.
To program all the tracks on a CD at once,
proceed to step 5 while “AL” appears in the
display.
proceed to step 5 while “AL” appears in the
display.
4
Press > or . repeatedly until the
tracks you want appears in the display.
tracks you want appears in the display.
5
Press PUSH ENTER (or ENTER on the
remote).
remote).
The track(s) is (are) programmed. The
program step number appears, followed by
the total playing time.
program step number appears, followed by
the total playing time.
6
To program additional tracks, repeat
steps 3 to 5.
steps 3 to 5.
Skip step 3 to select tracks from the same
disc.
disc.
7
Press CD SYNC.
Deck B standby for recording. The REC
PAUSE/START indicator flashes.
PAUSE/START indicator flashes.
8
Press DIRECTION repeatedly to select
“g” to record on one side. Select
“j” (or RELAY) to record on both
sides.
“g” to record on one side. Select
“j” (or RELAY) to record on both
sides.
9
Press REC PAUSE/START.
Recording starts.
Recording to a tape (continued)
To
Cancel Program Edit
Clear a track from
the end
the end
Tip
To check the required tape length for recording a CD,
press EDIT after you have loaded a CD and pressed
CD. The required tape length for the currently
selected CD appears, followed by the total playing
time for side A and side B respectively (Tape Select
Edit).
press EDIT after you have loaded a CD and pressed
CD. The required tape length for the currently
selected CD appears, followed by the total playing
time for side A and side B respectively (Tape Select
Edit).
Note
You cannot use Tape Select Edit for discs containing
over 20 tracks or MP3 audio tracks.
over 20 tracks or MP3 audio tracks.
Timer-recording radio
programs
programs
To timer-record, you must preset the radio
station (see “Presetting radio stations” on
page 14) and set the clock (see “Setting the
clock” on page 9) beforehand.
station (see “Presetting radio stations” on
page 14) and set the clock (see “Setting the
clock” on page 9) beforehand.
1
Tune in the preset radio station (see
“Listening to the radio” on page 15).
“Listening to the radio” on page 15).
2
Press CLOCK/TIMER SET on the
remote.
remote.
“DAILY SET?” appears in the display.
3
Press
M or m repeatedly to select
“REC SET?”, then press PUSH ENTER
(or ENTER on the remote).
(or ENTER on the remote).
“ON” appears and the hour indication
flashes in the display.
flashes in the display.
Do This
Press PLAY MODE
repeatedly until “1 DISC” or
“ALL DISCS” lights up in
the display.
repeatedly until “1 DISC” or
“ALL DISCS” lights up in
the display.
Press CLEAR on the remote
when playback is stopped.
when playback is stopped.