D-Link DMI-128ESU User Manual

D-LINK ISDN TA DMI-128ESU+ 

38 

To enter into the programming mode from telephone sets, please follow the steps below: 
 
A) Use regular telephone set with DTMF -codes and plug into analog port A (TEL-A) or B (TEL-
B) Pick up the telephone you and wait for dial tone. 
C) Press flash / R -button and then ** 1 2 8 one the telephone keypad then you  
will hear a confirmation tone which indicate that the TA is now under the programming mode.   

 

To setup the corresponding settings, please check the above Easy Setup Table and execute the 
following steps. 
 
A). Press 0 0 * 0 to set global call select - ring TEL - A only (for example) 
B). Press *  * to store the setting into active profile.  
C). Repeat the procedure A) and B) for other settings. 
D). When finished with all settings, press * #  * to store all the updated settings into the  
      non - violate Memory.  

After you performed the * # * sequence, even when there is a power outage. The modified settings 
will still stored in the non-violate memory. After power resumes, you can recall the setting from 
user profile 0 or 1. If you hang up the phone before you execute the * # * sequence, then the TA 
will abort from the programming mode and return to idle mode.