D-Link DAS-3224_revB Software Guide
錯誤! 尚未定義樣式。
3
Chapter 2
DAS3series User Interface
This chapter describes the DAS3series user interface, the instructions describes how to using the
command-line interface, and also describes the command editing and command history features that
enable you to recall previous command entries and edit previously entered commands.
z
command-line interface, and also describes the command editing and command history features that
enable you to recall previous command entries and edit previously entered commands.
z
User Interface Mode
z
Access via the Console Port
z
Access using the Telnet Session
z
Command Syntax and Operating Regulation
User Interface Mode
The DAS3series provide the user access mode to allow user to access, it requires a password with
remote Telnet access, the user interface mode is called CLI Ex mode.
remote Telnet access, the user interface mode is called CLI Ex mode.
Access via the Console Port
Access to CLI Ex mode via the Console Port can be done using a VT100-compatile terminal directly
connected.
To access the CLI Ex mode via a direct VT100-compatible terminal connection to the Console Port,
use the following procedure:
No password required for Console access.
Step 1
connected.
To access the CLI Ex mode via a direct VT100-compatible terminal connection to the Console Port,
use the following procedure:
No password required for Console access.
Step 1
Set the communication parameters of a VT100-compatible terminal as follows:
Table 2-1
DAS3series Console Management Setting
Parameter
Setting
Baud rate
9600
Data bits
8
Parity None
Start bits
1
Stop bits
1
Flow control
None
Step 2
Connect the VT100-compatible terminal to the Console Port of the DAS3series front panel.
Step 3 Press
<Enter> a number of times until the “#” is display on the screen.
DAS3series IP-DSLAM
System Configuration Guide
System Configuration Guide