D-Link DAS-3224_revB Software Guide
16
錯誤! 尚未定義樣式。
Configuring the SNMP Status
The DAS3series supports SNMP v1 and v2c protocol, the SNMP status control the management data
transmitted between the device and the hosts to keep management communications private. Both the
device and the host must use the same SNMP Community.
transmitted between the device and the hosts to keep management communications private. Both the
device and the host must use the same SNMP Community.
Configuring the SNMP Community
The SNMP Community setting allows you to assign the community privilege levels. Two privilege
levels are support, read-only and read-write.
levels are support, read-only and read-write.
Table 3-10
SNMP Community Setting
Use this command to create the SNMP community information
#create snmp comm community <community> [access ro | rw]
Use this command to monitor the SNMP community information
#get snmp comm. [community community]
Use this command to delete the SNMP community information
#delete snmp comm community <community>
Parameters
Task
community <community>
This specifies the community name
Type: Mandatory
Valid values: String of up to 19 characters (All characters except ‘;’, ‘?’, and empty space)
[access ro | rw]
This specifies the access permissions given to managers with this community name. ‘ro’ implies read
only permissions and ‘rw’ implies read-write permissions.
only permissions and ‘rw’ implies read-write permissions.
Type: Optional
Default values: ro
Configuring the Host IP Address
The Host IP address of SNMP gives the permit IP and it correspond SNMP community. The
management host IP must in list of specific device.
management host IP must in list of specific device.
Table 3-11
SNMP Host Setting
Uses this command to create the SNMP host IP address with it relate community.
#create snmp host ip <ipadd> community <community>
Uses this command to monitor the SNMP host IP address with it relate community.
#get snmp host [ip ipadd] [community community]
Uses this command to delete the SNMP host IP address with it relate community.
#delete snmp host ip <ipadd> community <community>
Parameters
Task
[ip ipadd]
This specifies the IP address of the manager that has access permissions
Type: Mandatory
[community community]
This specifies the community name. This must be a valid community in the snmp community table of
system.
system.
Type: Mandatory
DAS3series IP-DSLAM
System Configuration Guide