D-Link DAS-3224_revB User Manual
42
DAS3 Series Operation Menus
4.3.9 Bridge
Configuration
The bridge configuration allows you to control the system bridging parameters.
Figure 4-26
Bridge Configuration Dialog
Table 4-16
Bridge Configuration Dialog Description
Item
Description
Aging Time
The timeout period, in seconds, for aging out dynamically learned forwarding
information from CPEs. The value 0 can be configured when aging is to be
stopped.
Valid values: 10 ~ 1,000,000
information from CPEs. The value 0 can be configured when aging is to be
stopped.
Valid values: 10 ~ 1,000,000
Uplink Aging Time
The timeout period, in seconds, for aging out dynamically learned forwarding
information from uplink side port. This is used only for full bridge
configuration. The value 0 can be configured when aging is to be stopped.
Default is set to 600 sec.
Valid values: 10 ~ 1,000,000
information from uplink side port. This is used only for full bridge
configuration. The value 0 can be configured when aging is to be stopped.
Default is set to 600 sec.
Valid values: 10 ~ 1,000,000
Dnlink (Slave) Aging Time
The timeout period, in seconds, for aging out dynamically learned forwarding
information learned from the downlink device. The value 0 can be configured
when aging is to be stopped. Default is set to 600 sec.
Valid values: 10 ~ 1,000,000
information learned from the downlink device. The value 0 can be configured
when aging is to be stopped. Default is set to 600 sec.
Valid values: 10 ~ 1,000,000
This is used to specify whether the unknown unicast packets are to be flooded
or not. The value for this is used along with per vlan configuration for flood
support to determine if flooding has to be done for unknown unicast packet.
or not. The value for this is used along with per vlan configuration for flood
support to determine if flooding has to be done for unknown unicast packet.
Flood Support
This is used to specify whether the broadcasting is supported or not. The value
for this is used along with per vlan configuration broadcast support, to
determine if broadcasting has to be done for the broadcast packet.
for this is used along with per vlan configuration broadcast support, to
determine if broadcasting has to be done for the broadcast packet.
Broadcast Support
Multicast Support
Used to specify whether the multicast is supported or not.
AMS
Software Specification and Introduction Guide