D-Link DAS-3224 User Manual
D-Link DAS-3248 IP DSLAM
111
get arp
Description: Use this command to display either the full ARP table or a
single entry.
Command Syntax: get arp [ip ip-address]
Parameters
Name
Description
ip ip-address
IP address corresponding to the media-dependent
ìphysicalî address
Type: Mandatory
Valid values: Any valid class A/B/C IP address
ìphysicalî address
Type: Mandatory
Valid values: Any valid class A/B/C IP address
macaddr mac-address
The media-dependent ìphysicalî address
Type: Mandatory
Valid values: 0:0:0:0:0:1 - ff:ff:ff:ff:ff:fe
Type: Mandatory
Valid values: 0:0:0:0:0:1 - ff:ff:ff:ff:ff:fe
Output Fields
FIELD
Description
If Name
This specifies the physical interface for the media. It may
be: eth-0 - *. This entry contains bridge management
information.
be: eth-0 - *. This entry contains bridge management
information.
Type
This defines the type of mapping in use. The value
Invalid has the effect that this entry is not used. It may
be: Static, Dynamic, Other
Invalid has the effect that this entry is not used. It may
be: Static, Dynamic, Other
Mac Address
The media-dependent ìphysicalî address
Ip Address
IP address corresponding to the media-dependent
ìphysicalî address
ìphysicalî address
Caution
The specified interface should pre-exist. Please refer to the create
ethernet intf command.
ethernet intf command.
References
• delete arp command
• get arp command
• create ethernet intf command
• create ethernet intf command
• ip route related commands.
5.5.15 Bridge Mode Commands
get bridge mode
Description: Use this command to get the current bridging mode.
Command Syntax: get bridge mode