D-Link DAS-3224 User Manual
D-Link DAS-3248 IP DSLAM
164
HSSL Port Id : 1 Baud Rate : 9600
Data Bits : 8 Stop Bit : 2
Parity : Even U ART Mode : Polling
Application Type : Console
Data Bits : 8 Stop Bit : 2
Parity : Even U ART Mode : Polling
Application Type : Console
$
$
$
Output Fields
FIELD
Description
CpeUtopiaMode
Mode of operation of CPE side Utopia interface
NetUtopiaMode
Mode of operation of NET side Utopia interface
CpeUtopiaMaster
This specifies whether CPE side Utopia interface is
master
master
NetUtopiaMaster
This specifies whether NET side Utopia interface is
master
master
MaxEthMacPhy
This specifies the maximum number of MACs that
can be configured
can be configured
ColumbiaIdSel
Specifies the address bit in the PCI bus, which is
connected to IDSEL pin of the Columbia
connected to IDSEL pin of the Columbia
CpeUtopiaFreq
CPE Frequency for Utopia Interface
Eth Speed
This specifies the speed of operation. Supported
speeds are – 10 Mbps, 100 Mbps, and 1000 Mbps.
It is a bitmask.
speeds are – 10 Mbps, 100 Mbps, and 1000 Mbps.
It is a bitmask.
SelfMacAddr
This specifies the self MAC address
EthPortIdSel
This specifies the address bit in the PCI bus, which
is connected to IDSEL pin of the Ethernet device
is connected to IDSEL pin of the Ethernet device
EthType
This specifies the Defines the ethernet types – data
, mgmt, or both. It is a bitmask.
, mgmt, or both. It is a bitmask.
Num of LBRams
This specifies the number of LBRams in the
system.
system.
Num of Chips
This specifies the number of Chips in the system.
Num of Ports
This specifies the number of Ports per Chip in the
system.
system.
Interface Type
This specifies the InterfaceType. Following are the
values it can take – Host Bus, PCI, Utopia
values it can take – Host Bus, PCI, Utopia
Chip Type
This specifies the Type of Chip – G24, G16, and
octane.
octane.
Serial Number
This specifies
the vendor specific string that
identifies the vendor equipment
.
Vendor Id
This specifies the binary vendor identification field.
Version Number
This specifies
the vendor specific
version number
sent by this ATU as part of the initialization
message
message
Base Addr
This specifies the base address of the chip.
LBRam
This specifies the LBRam associated with the chip
Logical To Physical
Port Mapping
Port Mapping
This specifies the Logical To Physical Port
Mapping.
Mapping.
No of UARTs
This specifies the number of UARTs configured.
HSSL Port Id
This specifies the HSSL port to be used for UART.
Baud Rate
This specifies the Baud Rate of the port
Data Bits
This specifies the number of data bits to be used
Stop Bit
This specifies the stop bits used on HSSL – 1, 2,
1.5
1.5
Parity
This specifies the parity used on HSSL – even, odd,
none
none
UART Mode
This specifies the UART Mode – polling, interrupt
based
based
Application Type
This specifies the application name using this
UART.
UART.