D-Link DAS-3224 User Manual

 

86

 

  get interface stats   

Description:    Use this command to view statistics for one interface or all 

the interfaces.   

Command Syntax:    get interface stats [ifname interface-name ]   

Name   

Description   

 

Interface name, for which configuration is to be 
modified or viewed.   
Type: Get    -Optional  Modify  - Mandatory 
Valid values : eth-*,atm-*,aal5-*, eoa-*, dsl-*, dslf-*,   
dsli-*, aggr-*, ehdlc-*.  

trap enable|disable   

Indicates whether linkUp/linkDown traps should be 
generated for this interface.   
Type: Modify –    Optional Valid values : enable Or 
disable  

Verbose Mode On 

 

Field   

Description   

Interface   

This uniquely identifies the interface, for which infor-
mation is being displayed. It may be: eth-0, eth-1, 
atm- *, aal5-*, eoa-*, dsl-*, dslf-*, dsli-*, aggr-*, eh-
dlc-*.  

Description   

This is general information about the interface   

Type   

The type of interface, distinguished according the 
physical/link/network protocol, immediately below 
the IP layer. It may be: ATM, ETHERNET, AAL5, 
EOA, DSL, FAST, INTERLEAVED, AGGR. EHDLC.  

Mtu   

The size (in bytes) of the largest packet, which can 
be sent/received on this interface in octets.   

Bandwidth   

The current bandwidth of the interface, in bps.   

Phy Addr   

Interface's address, at its protocol sublayer.   

Admin Status   

This is the desired state of the interface. It may be: 
Up, Down.