D-Link DFL-1600 Reference Guide
2.28. NATPOOL
These log messages refer to the NATPOOL (Events related to NAT Pools) category.
2.28.1. uninitialized_ippool (ID: 05600001)
Default Severity
Log Message
NATPool <poolname> has not been initialized
Explanation
The NATPool is not initialized. This can happen if the NATPool
contains no valid IP addresses. If the NATPool is configured to use an
IPPool, no IP addresses have been received form the IPPool.
contains no valid IP addresses. If the NATPool is configured to use an
IPPool, no IP addresses have been received form the IPPool.
Gateway Action
drop
Recommended Action
If the NATPool is configured to use an IPPool, verify that addresses
have been loaded from IPPool.
have been loaded from IPPool.
Revision
1
Parameters
poolname
2.28.2. removed_translation_address (ID: 05600002)
Default Severity
Log Message
Translation IP address <address> does no longer exist in NATPool
<poolname>
<poolname>
Explanation
The translation IP has been removed by a configuration change. The
connection is no longer valid and will be closed.
connection is no longer valid and will be closed.
Gateway Action
close
Recommended Action
None.
Revision
1
Parameters
address
poolname
poolname
2.28.3. reconf_state_violation (ID: 05600003)
Default Severity
Log Message
State
violation
during
re-mapping
to
STATFUL
NATPool
<poolname>.
Explanation
The NATPool's configuration has changed to STATEFUL. This
connection's translation IP violates the stateful NATPool. Connection
will remain open but will no longer be attached to this NATPool.
connection's translation IP violates the stateful NATPool. Connection
will remain open but will no longer be attached to this NATPool.
Gateway Action
decouple
Recommended Action
None.
2.28. NATPOOL
Chapter 2. Log Message Reference
333