KitchenAid 30" Combination Wall Oven with Even-Heat™ True Convection (Lower Oven) Dimensional Illustrations

KEMS309E

KOCE500E

KOCE507E

* 

NOTE: The cabinet height can be between 41" (104.1 cm) and 41

1

2

" 

(105.6 cm) for microwave/oven combination.

Because Whirlpool Corporation includes a continues commitment to improve our 

products, we reserve the right to change materials and specifications without notice.

Dimensions are for planning purposes only. For complete details, see Installation 

Instructions packed with product. Specifications subject to change without notice.

If codes permit and a separate ground wire is used, it is 
recommended that a qualified electrical installer determine that the 
ground path and the wire gauge are in accordance with local codes.
Check with a qualified electrical installer if you are not sure the oven 
is properly grounded.
This oven must be connected to a grounded metal, permanent 
wiring system.
Be sure that the electrical connection and wire size are adequate 
and in conformance with the National Electrical Code, ANSI/NFPA 
70-latest edition or CSA Standards C22.1-94, Canadian Electrical 
Code, Part 1 and C22.2 No. O-M91-latest edition, and all local 
codes and ordinances.
To properly install your oven, you must determine the type of 
electrical connection you will be using and follow the instructions 
provided for it here.
•  Oven must be connected to the proper electrical voltage and 

frequency as specified on the model/serial/rating plate. See the 
following illustration.

KOCE507E/KOCE500E 120/240 32

30

8000

KOCE507E/KOCE500E 120/208 30

28

6600

 *

 Amperage values noted above are for information purposes only: the 
units are rated in watts.

Ref. W10725683B

2/10/15

•  Models rated from 7.3 to 9.6 kW at 240 volts (5.4 to 7.4 kW at 208 

volts) require a separate 40-amp circuit. Models rated at 4.8 kW 
and below at 240 volts (3.6 kW and below at 208 volts) require a 
separate 30-amp circuit.

•  A circuit breaker is recommended.
•  Connect directly to the fused disconnect (or circuit breaker box) 

through flexible, armored or nonmetallic sheathed, copper cable 
(with grounding wire). See “Make Electrical Connection” section.

•  Flexible conduit from the oven should be connected directly to the 

junction box.

•  Do not cut the conduit. The length of conduit provided is for 

serviceability of the oven.

•  A UL listed or CSA approved conduit connector must be provided.
•  If the house has aluminum wiring, follow the procedure below:
 

1.  Connect a section of solid copper wire to the pigtail leads.

 

2.  Connect the aluminum wiring to the added section of copper 

wire using special connectors and/or tools designed and UL 
listed for joining copper to aluminum.

Follow the electrical connector manufacturer's recommended 
procedure. Aluminum/copper connection must conform with local 
codes and industry accepted wiring practices.
For power requirements, refer to the following table.