Nikon R1 User Manual
61
z
F
unctions and use of the
SB
-R200
2
Using the SB-R200
1
Slide open the battery chamber lid
in the direction of the arrow.
in the direction of the arrow.
2
Install the battery, then close the
battery chamber lid by sliding it into
place.
battery chamber lid by sliding it into
place.
Use CR123A (3V) lithium batteries.
Replacing the battery
When the SB-R200’s battery power is
weak, the green ready-light blinks after the
power has been turned on or after the flash
has fired
weak, the green ready-light blinks after the
power has been turned on or after the flash
has fired
• Replace the battery.
3
Slide the SB-R200’s Mounting Foot
into the Speedlight Stand AS-20’s
Speedlight Mounting Shoe and
slide the lock switch.
into the Speedlight Stand AS-20’s
Speedlight Mounting Shoe and
slide the lock switch.
The Mounting Foot cannot be inserted in
reverse.
reverse.
• Slide the lock switch until it stops and make
sure that the red part can no longer be seen.
u Attaching the SB-R200 to the front of the lens
• The SB-R200 can be attached to the front of the lens using the Attachment Ring SX-1
ON/OFF
ON/OFF
ON/OFF
WIR
ELE
SS
SPE
EDL
IGH
T
AS-20
LOCK LOCK