Nikon MC-36 10-pin Remote Release (D2-series, D1-series, D200, D100 w/MB-D100) User Manual
En
7
The Illuminator/Lock Button
The Illuminator/Lock Button
Press the illuminator/lock button (
Press the illuminator/lock button (
) briefl y to
activate the control panel backlight. The back-
light will remain lit for about six seconds; press-
ing the arrow button (
light will remain lit for about six seconds; press-
ing the arrow button (
) while the backlight is
on extends the timer for another six seconds.
To lock all controls except the shutter-re-
lease (
) and illuminator/lock buttons, press
the illuminator lock button until the lock icon
(
(
) is displayed in the control panel. To release
the lock, press the illuminator/lock button until
the lock icon is no longer displayed.
the lock icon is no longer displayed.
Parts of the MC-36 (3/3)
Connecting the MC-36
1 Turn the camera off .
2 Check that the “TIMER ACTIVE” (
2 Check that the “TIMER ACTIVE” (
) and “RE-
LEASE” (
) indicators are not displayed.
3 Remove the 10-pin terminal cover from the
camera. Keeping the mark on the 10-pin
connector (
connector (
) aligned with the mark on the
camera body, insert the connector as shown
and then tighten the locking nut.
and then tighten the locking nut.
Disconnecting the MC-36
After checking that the “TIMER ACTIVE” (
) and “RE-
LEASE” (
) indicators are not displayed, turn the
camera off and disconnect the MC-36. Replace
the 10-pin terminal cover.
the 10-pin terminal cover.
The “TIMER ACTIVE,” “SET,” and “RELEASE” Indicators
If this fl ashes
It means this; do this to turn it off
TIMER ACTIVE
Timer active (page 13); press TIM-
ER START/STOP button (
ER START/STOP button (
).
SET
Settings can be modifi ed (page
8); press SET button (
8); press SET button (
).
RELEASE
(TIMER
ACTIVE not
fl ashing)
Manual release active (page 15);
release shutter-release button
(
release shutter-release button
(
; if button is in HOLD position,
release shutter-release lock).