Canon LV-7265 Instruction Manual

❼

Displays the status of the lamp / filter / projector usage and the current signal. This item has three pages. The infor-
mation included is as follows: 

[Remaining lamp time] (%)  

[Lamp counter] (H)

[Filter counter] (H)

Remaining Lamp/Lamp Counter
The projector has the Quiet mode. The lamp life varies depending on two modes: quiet mode and normal mode.
The [Remaining lamp time] shows the percentage of remaining bulb life. The [Lamp counter] shows the amount of 
lamp usage (hours).
•  When the remaining lamp time reaches 0%,  the “Replace with the new lamp.” message will be displayed. Re-

place with the new lamp.

  See page 

58

 for lamp replacement.

•  The message for lamp replacement will be displayed under the following conditions:
  - one minute after the projector has been powered on.
  - when the POWER ON/STAND BY button on the projector cabinet or the POWER OFF button on the remote 

control is pressed.

  To cancel the message, press any button on the projector cabinet or the remote control.
•  When the remaining lamp time reaches 0%, the Remaining lamp time bar indicator changes from 0% to 100(H) 

in red and starts counting down.

  When the remaining lamp time reaches 0 hours, the projector will not turn on. 

LV-7365

2000

3000

LV-LP30

LV-7265/LV-7260

2000

3000

LV-LP26

LV-X7

3000

4000

LV-LP27

[Source index] 

[Horizontal frequency]

[Vertical frequency] 

[Input signal type]

[Video type] 

[Sync type]

[Sync polarity] 

[Scan type]