Canon PowerShot Pro 90 IS User Guide
54
Shooting - Letting the Camera Select Settings
Continuous Mode
Use this mode to shoot successive frames while the shutter button is pressed.
1
Press the
button.
• Press the
button several times to display
the
icon in the display panel. The icon will
also appear in the LCD monitor or viewfinder if
it is on.
it is on.
• You can cancel the continuous mode by
pressing the
button until the
icon
disappears.
2
Shoot the image.
• While the shutter button is pressed all the way,
shots are taken at approximately 0.7 images
per second* when the image quality is set to
Large / Fine. Release the shutter button to stop
shooting.
*
per second* when the image quality is set to
Large / Fine. Release the shutter button to stop
shooting.
*
This figure reflects standard shooting conditions
established by Canon. Actual figures may vary
according to the subject and shooting conditions.
established by Canon. Actual figures may vary
according to the subject and shooting conditions.
• The shooting procedures are the same as those
described in steps 6-8 in the Quick Start section
(p. 9).
(p. 9).
• This mode cannot be selected in the
,
or
shooting mode.
• An externally mounted flash will not fire in this mode.
• The built-in flash can be used, but the interval between images will lengthen to
• The built-in flash can be used, but the interval between images will lengthen to
accommodate the flash recharge time.
• Successive frames can be shot until the CF card is filled.
• The interval between frames may lengthen somewhat when the internal memory
• The interval between frames may lengthen somewhat when the internal memory
gets full.
• Turning the camera off cancels the setting.