Canon MP25-MG User Manual

Page of 2
 
–  Used for designating the decimal point position (+ 0 2 3 4 6 F) 
 
    for calculated results.
+ (Add-Mode) – Addition and subtraction functions are performed 
with an automatic 2-digit decimal. It is convenient for currency 
calculations.
F (Floating Decimal Point) – All effective numbers up to 12 digits 
are printed or displayed.
  COMO CAMBIAR LA CINTA
PRINTED IN CHINA
INSTRUCTIONS
INSTRUCCIONES
   INSTALLING PRINTING PAPER
   
REPLACING BACKUP BATTERY
Memory backup battery retains the tax rate, calendar and clock setting, when the  
power is off or even when the AC cord is disconnected.
Battery : 1 Lithium battery (Type : CR2032)
Battery life : Backup time 2000 hours
Replace back-up battery
CAUTION: Risk of explosion if battery is replaced by an incorrect type. Dispose of
                  used batteries according to the instruction.
ESPAÑOLA
  REPLACING THE INK RIBBON
  ESPECIFICACIONES
  ANTES DE EMPEZAR
  INSTALANDO PAPEL DE IMPRESIÓN
  DECIMAL POINT SELECTOR SWITCH
 
  INTERRUPTOR SELECTOR DE PUNTO DECIMAL
  ROUNDING SWITCH
  CONMUTADOR DE REDONDEO
  GRAND TOTAL / RATE SET SWITCH
  TECLA DE GRAN TOTAL / RATE SET
   IMPRESIÓN / RECUENTO ITEM
Note: Turn the power off.
1) Remove the cover and lift up the paper arm.
2) Lift ribbon spools off the shafts. Discard the old ribbon and spools.
3) Place the ribbon spool on the left spool pin and push it down until it clicks.
4) Thread the ribbon along the outer edge of the side guide, making sure 
that the black half of the ribbon is still on the top.
5) Place the ribbon between the printing ring and printing roller. Thread the 
ribbon along the outer edge of the left side guide.
6) Place the other ribbon spool on another spool pin.
7) Push the spool down until it clicks.
8) Take up any ribbon slack by rotating the left spool counterclockwise.
9) Replace the printer cover.
IMPORTANT: Use only the same type of ribbon spools.
  BEFORE STARTING
ENGLISH
– Used for round-up [     ] , round-off [5/4], or round-down  [     ]to the 
pre-selected decimal digits in the result.
Print Off – Entries and results will appear on the display, but will 
not be printed out.
Print On – Entries and results will appear on the display and will be 
printed out.
Item – Set switch to "ITEM" to count the number of times the
     ,      ,       and       keys have been pressed. The item count will 
be printed on the left hand side of the paper roll (up to 999 times) 
when the     ,     ,      or       keys are pressed.
 
– When the calculations are performed with the GT switch set to 
"ON", the total(s) are accumulated in the grand total memory. 
Each time      is pressed, the subtotal number is printed with the 
symbols G+. When      is pressed, the intermediate grand total is 
printed with the symbols G    . Press      successively to get the 
grand total followed by the symbols G   .
 
– Set switch to "TAX RATE SET" for setting or recalling the TAX rate.
GRAND TOTAL
TAX RATE SET
  PRINT / ITEM COUNT SWITCH
In the following cases, when "E" is displayed, "ERR" is printed, the keyboard is 
electronically locked, and further operation is impossible. 
Press       to clear the overflow. The overflow occurs when:
1.  The result or the memory content exceeds 12 digits to the left of the decimal 
point.
2.  Dividing by "0".
3.  The sequential operation speed is faster than the calculation processing speed. 
(Buffer Register Overflow)
Electromagnetic interference or electrostatic discharge may cause the display 
to malfunction or the memory, currency rate and tax rate to be lost or altered. 
Should this occur, use the tip of a ballpoint pen 
(or similar sharp object) to press the [RESET] button on 
the back of the calculator. After resetting be sure to set
the calendar, clock and tax rate again.
Power Source: AC120V, 60Hz
Operation Temperature: 0°C to 40°C (32°F to 104°F)
Calculating Capacity: 12 digits maximum                                           
Dimension: 320mm (L) x 193 mm (W) x 71mm (H) / 
 
12-39/64" (L) x 7-39/64" (W) x 2-51/64" (H)
Weight: 1,532 g (3.37 lbs)
(Subject to change without notice)
    The socket-outlet shall be installed near the equipment and shall be easily
     accessible. 
For CA, USA Only
Included battery contains perchlorate material - special handling may apply.
See http://www.dtsc.ca.gov/hazardouswaste/perchlorate/ for detail.
The top case, bottom case, printer cover and battery cover in this 
product are made from recycled Canon copier plastic.
  OVERFLOW
   SPECIFICATION
   REEMPLAZO DE LA BATERÍA DE RESPALDO
  FUNCIÓN DE REBOSE
“ERR”
    La toma de corriente debe instalarse cerca del equipo y debe ser 
    fácilmente accesible.
 
Para el Ca, los E.E.U.U. Solamente
La batería incluida contiene el material del perclorato - El manejo especial debe 
ser aplicado.Para el detalle, por favor ver
http://www.dtsc.ca.gov/hazardouswaste/perchlorate
 
AC120V, 60Hz
Peso: 1,532 g (3.37 lbs)
320mm (An) x 193 mm (Pr) x 71mm (Al) / 
12-39/64" (An) x 7-39/64" (Pr) x 2-51/64" (Al)
E-IM-2471
1)  Remove the insulation tape at the back of calculator. (Figure      )
2)  Remove the tape on the ink ribbon of calculator. (Figure     ,     )
3)  Plug in AC power cord. (Figure    )
4)  Turn the power switch on. (Figure     )
5)  Press [RESET] key before use. (Figure     )
a
b
c
d
e
f
e
f
b
c
a
d
Note : Turn the power off
1) Remove the printer cover (Figure  
    ) and lift up the paper arm (Figure      ).
2) Replace the printer cover (Figure  
    ).
  • When inserting the paper, cut the edge of the paper as shown (Figure  
    ).
3) Place the new paper roll on the arm. The edge of the paper should be positioned 
as shown (Figure  
    ).
  • Suitable paper roll -- Width : 57mm (2-1/4”) / Diameter: 86mm (3-3/8”)
4) Insert the paper into the slit located of the machine as indicated (Figure  
    ).
5) Turn the power switch on (Figure  
    ). Press the paper feed key        to advance 
the paper (Figure  
    ).
e
f
b
c
a
d