Canon VB-R13VE Manual

112

Sets initial settings, such as video quality compensation, at camera start up. If you change settings, the changes are 

immediately reflected in the video display area and Viewer, even if you do not click [Apply].

A message confirms whether you want to display the current camera status as the initial settings if the current camera 

status differs from the settings registered as the initial settings when you access [Initial Setting].

If you click [OK], the current camera status is displayed as the initial settings. If you click [Cancel], the current camera 

status is ignored and the settings registered as the initial settings are displayed.

Camera Position

Sets the camera position at camera start up.

Note

You can operate the frame on the panorama screen or the video display area to perform pan, tilt, and zoom operations.

[Pan/Tilt/Zoom position] 

Register the present pan, tilt, and zoom positions as the initial setting. If you select [Unregister], the camera will return to the 

pan, tilt, and zoom positions as when the camera was turned off the next time it is booted.

Note

When [Digital PTZ Position] is set to [Unregister], you can perform pan, tilt, and zoom operations on the video display area using Area 
Zoom (P. 69).

[Digital PTZ Position]

Register the current digital PTZ position as the initial setting.

If you select [Register], a yellow frame is displayed in the video display area. Operate the frame to specify the Digital PTZ 

trim position during startup.

[Camera] > [Initial Setting]
Setting Initial Video Settings

Important

If you change the zoom after configuring the intelligent function, privacy mask, preset, and ADSR, those settings must be configured 
again.

The following settings can be configured here.

• Camera position

• Camera Settings

H651

H652

M50

R12

R13

R13 R12 M50

M50

M50 H652 H651