Canon VB-R13VE Manual

Setting Page

123

You can create a panorama image that captures the entire area that can be captured by the camera.

Created panorama images are displayed in the Viewer and part of the Setting Page.

Creating a Panorama Image

A panorama image can be used in the Viewer and for a privacy mask by clicking [Apply] to save it to the camera after

capturing.

Note

• While a panorama image is being captured, the Image Stabilizer is temporarily disabled.

• The following users will be disconnected while creating a panorama image.

– All users except for administrators
– Users not connected via RTP

• When a small value is entered for [Maximum Frame Rate: Video Transmission] (P. 105) in [Video] > [JPEG], panorama capture is slowed

down.

Set the range for panorama creation. This enables the panorama creation time to be reduced.

[Specify the panorama creation area]

If you select [Specified], the panorama image is created within a set area that can be captured by the camera. If

you select [Not specified], the panorama image is created within the entire area that can be captured by the

camera.

If you selected [Not specified], proceed to step 3.

[Camera] > [Panorama]
Creating a Panorama Image

Important

• If you change the privacy mask settings in [Privacy Mask], it is recommended that you create the panorama image again to reflect the

new privacy mask settings in the panorama image.

• If you have changed the camera installation method settings, recapture the panorama image.

R13 R12 M50

The following settings can be configured here.

• Panorama Creation Area

• Panorama Screen

• Capture Settings

Set [Panorama Creation Area]