Canon VB-R13VE Manual

Detecting/

S

et

ting C

ameras

2

17

Note

• This setting is enabled only for the cameras for which administrator accounts can be registered. So the setting can be disabled 

depending on the model you use.

• Administrator accounts can be registered after detecting cameras as well.

• The administrator name and administrator password set here will be applied to all the cameras for which no administrator 

account has been registered. If you want to use different administrator name and administrator password for each camera, do not 
set the administrator account here and register the accounts after detecting cameras.

During the search, the following screen appears. You can stop the search part way through by clicking [Stop].

When searching is finished, the results are displayed in the camera list.

Note

• If you perform search with the [Register administrator account upon detection] checkbox cleared, and a camera without registered 

administrator account is detected, a message is displayed. Register an administrator account later.

• If a camera is not detected, even though it is connected to the same network, click 

 again to perform detection.



Adding Already Detected Cameras

After executing [Search Cameras], cameras connected to the same network are automatically detected. When a 

camera is detected, 

 on the toolbar is displayed in green. If you have the mouse pointer over the button, it will 

display the number of detected cameras.

Go back to the [Search Cameras] dialog box, and click [Search].