Canon VB-R13VE Manual
46
Specify the IPv4 address to detect cameras in your currently operating system, and add them to the camera list. You can
either detect them one by one manually, or load the CSV file to detect multiple cameras at once.
Note
A maximum of 64 detected cameras can be added to the camera list. If you exceed the maximum number of cameras (64) when you try to
add cameras, an error message is displayed. In this case, a camera cannot be added until you delete cameras from the camera list
(P. 23).
add cameras, an error message is displayed. In this case, a camera cannot be added until you delete cameras from the camera list
(P. 23).
Detecting a Single Camera
Specify an IPv4 address to manually detect a camera connected to a different network segment.
The [Add Camera] dialog box is displayed.
(1)
[IPv4 Address]
Enter the IPv4 address of the camera to add.
Enter the IPv4 address of the camera to add.
(2)
[Administrator Name]
Enter the camera’s administrator information. The field will be grayed out and cannot be filled in if
[Authenticate using common authentication information] checkbox is selected.
(3)
[Administrator password]
Enter the administrator password for the camera. The field will be grayed out and cannot be filled in if
Enter the administrator password for the camera. The field will be grayed out and cannot be filled in if
[Authenticate using common authentication information] checkbox is selected.
(4)
[Authenticate using common authentication information]
Select this checkbox to perform authentication using the common authentication information (P. 24). If you
Select this checkbox to perform authentication using the common authentication information (P. 24). If you
select this checkbox, the administrator name and administrator password specified in the above (2) and (3)
are canceled and grayed out.
(5)
[Enable SSL communications]
Select this to connect to the camera using SSL communication. If you select the [Enable SSL
Select this to connect to the camera using SSL communication. If you select the [Enable SSL
Communications] checkbox, the self-signed certificate is checked. A message is displayed if you
authenticate a camera that has a problem with its self-signed certificate and has not been connected before.
(6)
Port number input field
Specify the port number to be used for camera connection. Normally, leave this set to the default.
The camera is added to the camera list.
Specifying an IP Address to Detect a Camera
1
Select [Camera List] > [Add Camera].
2
Enter the authentication information.
3
Click [OK].
(1)
(2)
(3)
(4)
(5)
(6)
(6)