Canon VB-R13VE Manual

80

(9)

[Detection Indicator]

The size marker changes position depending on the value of the [Area Ratio] setting. Adjust the motion 

detection settings while viewing the preview video and the Detection Indicator.

The colored bar changes depending on the value of the [Sensitivity] and the [Area Ratio] settings.

The other settings are the same as those for continuous recording (P. 75).



Intelligent Function Recording Settings

Tabs named [Rule 1] through [Rule 15] are displayed, as shown. Each tab can be configured individually.

(1)

[Do not record]
Do not record even when the conditions for this rule are met.

(2)

[Start Recording]
Start recording when the conditions for this rule are met. After selecting the item, configure the recording 

settings below the item.

Color of the 
Colored Bar

Meaning

Green

The detected motion does not reach the values specified in [Sensitivity] and [Area Ratio]. 
In this case, the colored bar remains to the left of the size marker.

Red

The detected motion exceeds the values specified in [Sensitivity] and [Area Ratio]. In this 
case, the colored bar remains to the right of the size marker.

Important

• If the recording period for a schedule ends while motion detection recording is in progress, recording will stop.

• The detection indicator is not affected by the [Duration] setting. Be sure to take the detection time into account when adjusting 

the motion detection settings.

• To perform motion detection on the Storage Server, you must specify [JPEG] for the [Video Format]. Also, if you simultaneously 

use more than one recording mode, all the [Video Format] settings must be [JPEG]. An error message is displayed if you try to 
use a format other than [JPEG] and motion detection on the Storage Server at the same time.

• Make the [Priority] setting on the [Recording Settings] tab lower than the priority of any of the other recording settings.

Colored bar

Size marker

Notification Indicator

(1)
(2)
(3)