Canon imagePROGRAF iPF840 MFP M40 Manual
7
Press ▲ or ▼ to select Automatic, Print Quality, or Print Length, and then press the OK button.
Adjusting Line Length
Adjusting Line Length
To ensure that lines in CAD drawings are printed at exactly the right length, use Adjust Length to adjust the
amount that paper is advanced.
There are two options in Adjust Length : AdjustmentPrint and Change Settings.
amount that paper is advanced.
There are two options in Adjust Length : AdjustmentPrint and Change Settings.
•
AdjustmentPrint
After a test pattern is printed, you will measure the discrepancy based on the results of printing.
After a test pattern is printed, you will measure the discrepancy based on the results of printing.
•
Change Settings
No test pattern is printed. Instead, you will measure a document already printed to determine the discrepancy.
No test pattern is printed. Instead, you will measure a document already printed to determine the discrepancy.
Additionally, two modes are available in both AdjustmentPrint and Change Settings : A:High or B:Standard/
Draft. Choose the mode that suits your particular printing application.
Draft. Choose the mode that suits your particular printing application.
•
A:High
This setting is applied when Highest or High is selected in Print Quality in the printer driver.
This setting is applied when Highest or High is selected in Print Quality in the printer driver.
•
B:Standard/Draft
This setting is applied when Standard or Fast is selected in Print Quality in the printer driver.
This setting is applied when Standard or Fast is selected in Print Quality in the printer driver.
Note
•
Always check the Adj. Priority values before using Adjust Length.
•
Use paper of the same type and size for adjustment as you will use for printing.
Paper to Prepare
When Using Rolls
•
An unused roll at least 10 inches wide
•
High-precision ruler
When Using Sheets
•
One sheet of unused paper of at least A4/Letter size
•
High-precision ruler
Perform adjustment as follows.
1
Load the paper.
•
•
•
Important
•
Always make sure the loaded paper matches the type of paper specified. Adjustment cannot be com-
pleted correctly unless the loaded paper matches the settings.
pleted correctly unless the loaded paper matches the settings.
2
On the Tab Selection screen of the Control Panel, press
◀ or
▶ to select the Settings/Adj. tab (
).
Note
•
If the Tab Selection screen is not displayed, press the Menu button.
3
Press the OK button.
The Set./Adj. Menu is displayed.
The Set./Adj. Menu is displayed.
iPF840 Series
Adjusting Line Length
Adjustments for Better Print Quality
Adjusting the feed amount
95