Canon imagePROGRAF iPF830 Manual
Cause
Corrective Action
The loaded paper is too small.
(When you have attempted to print a test
print sheet or other printer status informa-
tion.)
(When you have attempted to print a test
print sheet or other printer status informa-
tion.)
Press ▲ or ▼ to select Stop Printing, and then press the OK button.
PaprWidth Mismatch
PaprWidth Mismatch
Cause
Corrective Action
When Detect Mismatch in the Control Panel
menu is set to Pause or Hold Job, the width of the
loaded roll does not match the width specified in
Fit Roll Paper Width in the printer driver.
menu is set to Pause or Hold Job, the width of the
loaded roll does not match the width specified in
Fit Roll Paper Width in the printer driver.
Press ▲ or ▼ to select Print, and then press the OK button to resume print-
ing.
However, note that this error may cause paper jams and affect the printing
quality.
ing.
However, note that this error may cause paper jams and affect the printing
quality.
Press ▲ or ▼ to select Stop Printing, and then press the OK button.
Follow these steps to replace the roll to match the width specified in the printer
driver.
driver.
1.
Press ▲ or ▼ to select Change Paper, and then press the OK button.
(See "Removing the Roll Holder from Rolls.")
➔
User's Guide
2.
Replace with paper of the width configured in the printer driver.
The printer now starts printing the print job.
Make sure the roll width selected in the dialog box displayed when you select
Fit Roll Paper Width in the printer driver matches the width of the roll loaded
in the printer, and then try printing again.
Fit Roll Paper Width in the printer driver matches the width of the roll loaded
in the printer, and then try printing again.
Paper size not detected.
Paper size not detected.
Cause
Corrective Action
Paper has been loaded askew, or warped paper has been loaded.
Lift up the Release Lever and reload the
paper.
paper.
If "Not finished printing. Finish printing
remaining jobs?" is displayed on the Dis-
play Screen, press the OK button.
Printing will resume, starting from the
page on which the error occurred.
remaining jobs?" is displayed on the Dis-
play Screen, press the OK button.
Printing will resume, starting from the
page on which the error occurred.
If this error recurs after you reload the roll,
remove the Roll Holder from the printer,
push the roll firmly in until it touches the
Roll Holder flange, and reload the Roll
Holder in the printer.
remove the Roll Holder from the printer,
push the roll firmly in until it touches the
Roll Holder flange, and reload the Roll
Holder in the printer.
Because the Platen is soiled with ink or other substances, the size of the clear
film cannot be detected.
film cannot be detected.
Open the Top Cover and clean the entire
Platen.
Platen.
iPF850 Series
PaprWidth Mismatch
Error Message
Messages regarding paper
143