Canon Océ VarioPrint 6000+ Series Manual
Empty the chip tray
Introduction
The chip tray contains the paper chips that result from the punching process. The chip tray is
located at the lower left-hand side of the puncher (see
located at the lower left-hand side of the puncher (see
When to do
The printer stops when the chip tray is full. The operator panel displays a message. The message
asks you to empty the chip tray of the puncher.
asks you to empty the chip tray of the puncher.
Illustration
[52] Empty the chip tray
Procedure
1.
Open the front door of the puncher.
NOTE
Make sure that you empty the chip tray while the power switch of the puncher is in the 'I'
position. This enables the sensors to detect the action and automatically reset the punch
counter.
position. This enables the sensors to detect the action and automatically reset the punch
counter.
2.
Grasp handle K8 and pull out the chip tray.
3.
Empty the chip tray.
4.
Slide the chip tray back into place.
5.
Close the front door of the puncher.
Empty the chip tray
174
Chapter 10 - Optional finishers and other devices