Canon Océ VarioPrint 6000+ Series Manual

To make the square spine of the book, pressure is applied to the
spine. This process is called forming.
Touch 

FORM to specify the amount of spine form.

To make a good spine on different paper types, the amount of
spine form can be changed.
To change the amount of spine form:
• Touch 

NUMBER to change how many times the spine is pro-

cessed

• Touch 

PRESSURE to change the pressure

- AUTO

Touch 

AUTO to select the optimum amount of spine form, accord-

ing to the set thickness.

- NUMBER

Touch 

NUMBER to select how many times the form roller process-

es the spine. The available options are 1, 2, 3 or 4. An increase in
NUMBER increases the time taken to form the spine and can de-
crease the production rate for thin books. Alternatively, increase
the 

PRESSURE.

- PRESSURE

Touch 

PRESSURE to increase or decrease the pressure used to

form the spine.
Touch 

+ to increase the amount of spine form. Touch - to decrease

the amount of spine form. The range is -9 to +9. The default set-
ting is 0.

- THRESHOLD

Use 

THRESHOLD to choose whether a square spine is formed.

If the 

SET THICKNESS value is thinner than the THRESHOLD val-

ue, a square spine is not formed.
If the 

SET THICKNESS value is thicker than the THRESHOLD value,

a square spine is formed.
If the 

SET THICKNESS value is 1.5 mm or thicker, a square spine is

always formed.
The default value is 0.8 mm. The allowed range is 0.1 mm to 1.5
mm

The trim dimension is calculated automatically according to the
PAPER SIZE and SET THICKNESS.
If needed, the trim dimension can be changed. Touch 

TRIM to ad-

just the size of the finished book after the fore-edge is trimmed.
The maximum trim is 28 mm. The trim function can be turned off.

- AUTO

Touch 

AUTO to select the default trim position.