Canon PowerShot ELPH 190 IS Blue Manual
125
Before Use
Basic Guide
Advanced Guide
Camera Basics
Auto Mode
Other Shooting
Other Shooting
Modes
P Mode
P Mode
Playback Mode
Setting Menu
Wi-Fi Functions
Accessories
Appendix
Index
Cannot magnify!/Cannot rotate/Cannot modify image/Cannot modify/
Unselectable image.
•
The following functions may be unavailable for images that were renamed or already
edited on a computer, or images shot with another camera. Note that starred (*)
functions are not available for movies.
), Rotate* (
–
), Print List* (
Photobook Set-up* (
).
Exceeded selection limit
•
) or Photobook Set-up
•
correctly. Reduce the number of selected images and try again.
•
), Erase (
),
).
Naming error!
•
The folder could not be created or images could not be recorded, because the highest
supported folder number (999) for storing images on the card has been reached and
the highest supported image number (9999) for images in folders has been reached.
), or format the
Lens Error
•
This error may occur if the lens is held while it is moving, or when the camera is used
in dusty or sandy locations.
•
Frequent display of this error message may indicate camera damage. In this case,
contact a Canon Customer Support Help Desk.
A camera error was detected (error number)
•
If this error message is displayed immediately after a shot, the image may not have
been saved. Switch to Playback mode to check for the image.
•
Frequent display of this error message may indicate camera damage. In this case,
write down the error number (Exx) and contact a Canon Customer Support Help
Desk.
File Error
•
images that have been altered using computer software, even if the camera is
connected to the printer.
Print error
•
Check the paper size setting (
). If this error message is displayed when the
setting is correct, restart the printer and complete the setting on the camera again.
Ink absorber full
•
Contact a Canon Customer Support Help Desk to request assistance with ink
absorber replacement.
Wi-Fi
Connection failed
•
No access points were recognized. Check the access point settings (
•
A device could not be found. Turn the camera off and on again, and retry the
connection.
•
Check the device you want to connect to and make sure it is ready for connection.
Cannot determine access point
•
The WPS buttons on numerous access points were pressed simultaneously. Try
reconnecting again.
No access points found
•
Check to make sure that the access point is turned on.
•
When connecting to an access point manually, make sure that you entered the
correct SSID.
Incorrect password/Incorrect Wi-Fi security settings
•
Check the access point security settings (
IP address conflict
•
Reset the IP address so that it does not conflict with another.