Canon Océ ColorStream 3000 Manual
Adjusting the Pressure Rollers
Introduction
If a paper web with a different width was inserted, the position of the pressure rollers in
the paper output must be checked.
the paper output must be checked.
To avoid damage, the paper edge must not run directly along a pressure roller. To this
end, the two pressure rollers on the right-hand side in the paper path direction (1 and 2)
can each be moved to 3 positions (A), (B, (C). These positions are marked on the pressure
roller holder.
end, the two pressure rollers on the right-hand side in the paper path direction (1 and 2)
can each be moved to 3 positions (A), (B, (C). These positions are marked on the pressure
roller holder.
■
If a pressure roller runs outside of the paper web: This pressure roller must be moved
so that the distance between the paper web and the pressure roller is at least 10 mm
(0.39").
so that the distance between the paper web and the pressure roller is at least 10 mm
(0.39").
■
If a pressure roller runs on the paper web: This pressure roller must be moved so that
the distance to the edge of the paper web is at least 15 mm (0.59").
the distance to the edge of the paper web is at least 15 mm (0.59").
Note:
The position of the pressure rollers must be the same for both pressure roller holders.
If, for instance, pressure roller 1 is set to position B in the upper row, pressure roller 1
must also be set to position B in the lower row.
If, for instance, pressure roller 1 is set to position B in the upper row, pressure roller 1
must also be set to position B in the lower row.
To Adjust the Pressure Rollers
#
Proceed as follows:
Select the following menu on the operator panel:
'Configuration' -> 'Special functions' -> 'Setting the pressure rollers'.
'Configuration' -> 'Special functions' -> 'Setting the pressure rollers'.
1.
Chapter 6 - Operating the Printing System
148
Adjusting the Pressure Rollers