Canon Océ ColorStream 3000 Manual
Replacing the Light Protection Cover
Removing the Light Protection Cover
Caution:
Hot surfaces on developer stations
After a longer period of printing, the motor of the developer station may be hot. Do not
touch the motor.
After a longer period of printing, the motor of the developer station may be hot. Do not
touch the motor.
Attention:
Avoid damage
To remove a light protection cover, all developer stations in the relevant print unit must
be swiveled off.
To remove a light protection cover, all developer stations in the relevant print unit must
be swiveled off.
Attention:
Avoid incidence of light
All 10 slots must be occupied either with developer stations or light protection covers. If
a developer station is removed and stored without being replaced by another developer
station, a light protection cover must be fitted in this slot. If you wish to re-install a de-
veloper station, you must first remove the light protection cover.
All 10 slots must be occupied either with developer stations or light protection covers. If
a developer station is removed and stored without being replaced by another developer
station, a light protection cover must be fitted in this slot. If you wish to re-install a de-
veloper station, you must first remove the light protection cover.
To Remove the Light Protection Cover
#
Proceed as follows:
If the printing system has not yet stopped, click the 'Stop' button:
1.
If not all developer stations have been swiveled off in the relevant print unit,
select the following menus and elements on the operator panel:
select the following menus and elements on the operator panel:
■
'Replace consumables' -> 'Swivel developer stations' menu
■
'Select task': 'All - upper print unit' or 'All - lower print unit'
■
'Select action to be executed': 'Swivel off'
■
Click the 'Next' button.
■
Click the 'OK' button to start the swiveling process.
The developer stations are swiveled off.
The developer stations are swiveled off.
■
When swiveling off is finished, click the 'OK' button again.
2.
Chapter 6 - Operating the Printing System
194
Removing the Light Protection Cover