Canon Océ ColorStream 3000 Manual
Installing the cleaning corotron slide-in unit of the transfer
unit
unit
Attention:
To Install the Cleaning Corotron Slide-in Unit of the Transfer Unit
#
Proceed as follows:
Push in corotron slide-in unit
until it latches:
A) Upper print unit
B) Lower print unit
The gloves are no longer re-
quired.
until it latches:
A) Upper print unit
B) Lower print unit
The gloves are no longer re-
quired.
1.
Close all doors on the right-hand side of the printing system.
2.
On the operator panel, enter whether a new corotron was installed:
■
When you click the 'Yes' button:
The message on the operator panel is deleted automatically, the replacement
of the corotron is recorded in the 'Consumable history' menu and the
consumable counter is reset.
The message on the operator panel is deleted automatically, the replacement
of the corotron is recorded in the 'Consumable history' menu and the
consumable counter is reset.
■
When you click the 'No' button:
The consumable counter is not reset.
The consumable counter is not reset.
3.
Complete the corotron replacement on the operator panel:
■
To carry out further maintenance work directly afterwards, click the 'OK'
button.
The printing system remains in the 'Special functions' status.
button.
The printing system remains in the 'Special functions' status.
■
To complete all maintenance work, click the 'Ready' button.
All printing system assemblies are checked (duration around two minutes),
before the printing system is switched to the 'Stop' status.
To switch the printing system to the 'Ready' status, click the 'Ready' button
again.
All printing system assemblies are checked (duration around two minutes),
before the printing system is switched to the 'Stop' status.
To switch the printing system to the 'Ready' status, click the 'Ready' button
again.
4.
Chapter 9 - Replacing Expendables
420
Installing the cleaning corotron slide-in unit of the transfer unit