Canon EOS-1D X Mark II Manual

28

The instructions in this chapter are continued from page 27.
This is a connection mode available when using an access point 
compatible with WPS. In pushbutton connection mode (PBC mode), the 
camera and the access point can be connected simply by pressing the 
WPS button on the access point.



If multiple access points are active in the surrounding area, it may be 
more difficult to establish a connection. In such a case, try using 
[WPS (PIN mode)] to establish a connection.



Check the position of the WPS button on the access point in advance.



It may take approx. one minute to establish a connection.



Select [OK] and press <0> to go to 
the next screen.



Press the access point’s WPS button. 
For details about where the button is 
located and how long to press it, refer 
to the access point’s instruction 
manual.



Select [OK] and press <0> to 
establish a connection with the 
access point.



When a connection with the access 
point is established, the [IP address 
set.] screen (p.34) is displayed.