Olympus XZ-1 Introduction Manual

EN

If the camera does not work as intended, or if an error 
message is displayed on the screen, and you are unsure 
of what to do, refer to the information below to fi x the 
problem(s).

Insert recharged batteries in the correct direction.
“Inserting the battery and the SD/SDHC/SDXC 
memory card (sold separately)” (p. 13), “Charging 
the battery and setting up using the supplied CD” 
(p. 14), “Charging the battery with the supplied 
USB-AC adapter” (p. 17)
Battery performance may have been reduced 
temporarily due to low temperature. Take the 
batteries out of the camera, and warm them by 
putting them in your pocket for a while.

“Error message” (p. 72)

Cancel sleep mode.
If no operations are performed for the specifi ed 
time when the camera is on, the camera will 
enter sleep mode and the monitor will turn off 
automatically. While the camera is in sleep mode, 
pressing the shutter button will have no effect; to 
restore normal operation, operate the zoom lever 
or other camera controls. If no operations are 
performed for some time after the camera enters 
sleep mode, the camera will turn off automatically. 
Use the n button to turn the camera on.
Press the 

q button to switch to the shooting 

mode.
Wait until 

#(fl ash charge) stops blinking before 

taking pictures.

Condensation

*1

 may have occurred. Turn off the 

power, and wait for the camera body to become 
acclimated to the surrounding temperature and dry 
out before taking pictures.

*1

  Dew drops can form in the camera when it is 

suddenly taken from a cold location into a warm, 
humid room.

This condition may occur when the camera is 
pointed at an extremely bright subject under a clear 
sky and so on. The lines do not appear, however, 
in the fi nal image.

Shooting with fl ash in dark situations results in an 
image with many fl ash refl ections on dust in the air.