Olympus XZ-10 Instruction Manual

EN

•  To exit, unplug the USB cable from the camera while the picture selection screen is 

displayed.

Connect the camera to the printer using the supplied USB cable and turn 
the camera on.

•  When the camera is turned on, a dialog should be 

displayed in the monitor prompting you to choose a 
host. If it is not, select [Auto] for [USB Mode] (P. 51) in 
the camera custom menus.

Use 

FG to select [Custom Print].

•  [Do Not Remove USB Cable] will be displayed, followed 

by a print-mode selection dialog.

•  If the screen is not displayed after a few minutes, disconnect the USB cable and start 

again from Step 1.

Follow the operation guide to set a print option.

Select the type of printing (print mode). The available print modes are as shown below.

Prints selected pictures.

Prints all the pictures stored in the card and makes one print for 
each picture.

Prints multiple copies of one image in separate frames on a single 
sheet.

Prints an index of all the pictures stored in the card.

Prints according to the print reservation you made. If there is no 
picture with print reservation, this is not available.

This setting varies with the type of printer. If only the printer’s STANDARD setting is 
available, you cannot change the setting.

Sets the paper size that the printer supports.

Selects whether the picture is printed on the entire page or inside a 
blank frame.

Selects the number of pictures per sheet. Displayed when you have 
selected [Multi Print].

Select pictures you want to print. The selected pictures 
can be printed later (single-frame reservation) or the 
picture you are displaying can be printed right away.