Olympus E-5 Introduction Manual

Page of 172
118
EN
Cust
o
m
izi
n
g
 your
 c
a
mer
a
9
AF FOCUS ADJ.
You can use the AF sensor to fine-adjust the focusing position to a range of ±20 steps (–: closer, 
+: toward )). Normally, there is no need to change this.
[SET AF DATA]
Fine-adjust the AF default value and register the setting. You can also register the 
setting according to the lens.
[OFF]
AF focus adjustment is not performed.
[DEFAULT DATA]
Registers and applies all lens AF 
adjustment values not registered 
individually.
[LENS DATA]
Fine-adjusts the AF for each lens. You 
register the adjustment values for up to 20 
lenses.
x
Notes
• Depending on the adjustment made, the lens may not focus toward the ) or near side.
• When using a teleconverter, the teleconverter and lens are registered as a set.
• Only Four Thirds lenses can be registered.
[DATA LIST]
This displays the lens information registered with [LENS DATA] from [SET AF 
DATA]
. Select a lens from the list, and then check, delete, or edit the registration 
information.
To take pictures while slightly changing the AF adjustment value:
j After fine-adjusting the adjustment value, press the shutter button and repeatedly take pictures 
before pressing the 
i button.
Note the following when taking pictures to check the AF adjustment value.
• It is recommended that the record mode be set to a setting higher than YN when taking 
pictures.
• Be careful of camera shake, subject movement, and changes in the distance to the subject 
when taking pictures.
• It is recommended that you take a picture of a subject with strong contrast within approximately 
3 m (9.8 ft.) in the actual shooting environment (lighting and temperature).
• Avoid taking pictures against backlight.
 TIPS
LENS DATA SET
14-54 F2.8-3.5
14-54 F2.8-3.5
S/N 000000000
S/N 000000000
EC00
S/N 888888888
±88
+20
±88
W
T
CANCEL
SET
Use 
ac to adjust.
1 12-60 F2.8-4.0
2 14-54 F2.8-3.5
1 14-54 F2.8-3.5
2 12-60 F2.8-4.0
1 50-200 F2.8-3.5
DATA LIST
BACK
SET
When the same lens is registered 
multiple times, the adjustment 
value for the lens with v is 
applied.
Select which lens to use 
when the same lens is 
registered multiple times.
Select this to check, delete, or edit 
the selected lens.
s0033_e_00_0_unified.book  118 ページ  2010年11月16日 火曜日 午後5時24分