Olympus Tough TG-820 iHS Introduction Manual

Page of 83
33
EN
  In the ISO setting, although smaller values result in 
less sensitivity, sharp images can be taken under fully 
lit conditions. Larger values result in higher sensitivity, 
and images can be taken at fast shutter speeds even 
under low light conditions. However, high sensitivity 
introduces noise into the resulting picture, which may 
give it a grainy appearance.
Sequential shooting (Drive)
Pictures are taken sequentially while the shutter button 
is held down.
1
  Select the drive option in the function menu.
P
P
0.0
0.0
MENU
MENU
12
M
AUTO
WB
AUTO
WB
AUTO
ISO
AUTO
ISO
2
2
Single
2
 Use 
HI to select the setting option, and 
press the 
A button to set.
Option Description
o
One frame is shot each time the 
shutter button is pressed.
j
*1
The images are taken sequentially 
while holding down the shutter for up 
to 100 frames.
c
The camera takes sequential shots 
at approximately 15 frames/sec.
d
The camera takes sequential shots 
at approximately 60 frames/sec.
*1 
The shooting speed varies depending on the settings 
for [Image Size] (p. 33) or [Compression] (p. 36).
  When set to [
c] or [d], [Image Size] is limited to 
[3] or lower, and the ISO sensitivity is fi xed to [ISO 
Auto].
  When set to [j], the fl ash (p. 20) cannot be set to 
[Redeye]. When set to other than [o] or [j], the 
fl ash is fi xed to [
$Flash Off].
  When set to [
c] or [d], the digital zoom (p. 37) is 
not available.
  With settings other than [o], the focus, exposure 
and the white balance are fi xed when the fi rst frame 
is shot. 
Selecting the image size for still 
images (Image Size)
1
  Select the image size option in the function 
menu.
P
P
MENU
MENU
5
M
8
M
12
M
16:9S
AUTO
WB
AUTO
WB
AUTO
ISO
AUTO
ISO
0.0
0.0
12M